[. . . ] [. . . ] and power consumer is 5V/2A(max) or 12V/1A(max) Note: USB connect is used to 5V DC power supply only, not for data transmission With problems, please refer to User Manual from the provided CD for details. Package Contents: Your package ships with the following items: Network Power Splitter SP125 Terminal Block to 12V (1A) PowerJack Cable x 1pc. Minimum System Requirements POE Router ( PSE - Power supply ) USB to DC convert cable x 2 pcs. Interface Introduction: Front Panel : Back Panel Ports:(From left to right ) : * 12V out (1 Amp) : for IP Kamera or other power. Ports (Left to Right): * Lan Out: Normal network jack - no power input passed * USB port : User can use the 4 pcs UDB power supply through in this port, only output for users USB device. * Total Power wattage: 12 Watts * Power LED light: the green light will be on when power is received through RJ-45 jack from POE router * P+Data In : Receive power and data from POE router by normal RJ-45 cable jack. Hard ware Installation 1. To get power from POE router, please connect RJ45 cable (not crossed cable) from POE router output to the SP=125 port " P+Data In " 2. The USB ports, 12V Terminal Block port and Network (RJ45 Out) port on SP-125 will begin transmitting information and or power: * In front panel: User can connect "LAN OUT" to IP Camera / HUB / Router through RJ-45 jack to access network information. [. . . ] [. . . ]