[. . . ] Also pay close attention so as not to let the water and detergent come into contact with the cushions used in the product; doing so may result in deterioration. Clamps may be damaged and drums may drop, causing injury.
B
A
3
See Figure 4. Move the leg on your left (pipe ) in a clockwise direction until it is about 90 degrees from the pipe with the YAMAHA logo. [. . . ] Tighten the knobs loosened and fix the positions of the cymbal holders. Loosen the two knobs ((k) on the middle left) aligned at the base of pipe and the knob all the way ((m) on the lower left) on the slim pipe supporting pipe . Move pipe in a counterclockwise direction until it is about 90 degrees from around the vertical pipe the pipe with the YAMAHA logo. Tighten the three knobs loosened and fix the position of and the slim pipe supporting it. pipe
Stopper (2)
PRECAUTIONS
Before using, please read this assembly manual, and use this product in a safe and proper manner. Particularly in the case of children and young users, parents or an instructor should teach the children the proper manner in which to use the device.
*1 Use cable bands to bind cables to pipes in " *2 Not this manual. (Spare bands are included. )
8 9
HH65 (Hi-Hat Controller) (1)
KP65 (Kick Pad) (1)
Drum Key (1)
WARNING
If this symbol is ignored and the equipment is used improperly, fatal injury to persons or serious damage could occur.
Assembling the Rack System
1
Take out the rack system from the package and remove all the cushioning. Remove the bubble wrap on the pipes while assembling the rack system.
Do not let small children assemble or set up this product by themselves, or they may be injured. If this product is used with the rack system or a cymbal stand, make sure all bolts are tightened firmly. Also, when adjusting the height or angle, do not suddenly loosen the bolts. Loose bolts may result in the rack overturning or parts dropping, causing injury. Placement on a sloping, unstable surface or on steps may result in the product being unstable and subject to overturning. When setting the product, please pay close attention to the handling and setting of cables. Carelessly placed cables may cause the user and others to trip and fall. The rack may overturn or be damaged, resulting in injury.
The pipe ends may injure your fingers. Figure 3: Rack Assembly-1
10 Check that the entire rack system is stable. [. . . ] Insert the end of the L-shaped part of the stopper into the oval-shaped hole on the cymbal pad (shown with ) to set the cymbal pad on the cymbal holder. Attach the included round-shaped felt with a large hole-diameter to the cymbal holder, then attach the wing nut removed in step 1 and tighten it. Turn the wing nut until you are certain that the cymbal pad is attached. [. . . ]