[. . . ] To bi-wire, remove the links by loosening the terminal caps and use a separate 2-core cable from the amplifier to each pair of terminals. When bi-wiring, incorrect connection can also impair the frequency response (figure 5). [. . . ] When bi-wiring, incorrect connection can also impair the frequency response (figure 5). Keep the total impedance below the maximum recommended in the specification and use a low inductance cable to avoid attenuation of the highest frequencies. Before fine tuning, double check that all the connections in the installation are correct and secure. Moving the speakers further from the walls will reduce the general level of bass. Space behind the speakers also helps to create an impression of depth. Conversely, moving the speakers closer to the walls will increase the level of bass. There are 2 pairs of terminals at the back of the speaker which permit bi-wiring if desired. On delivery, the separate pairs are connected together with high-quality links for use with a single 2-core cable. For single cable connection, leave the links in place and use either pair of terminals on the speaker (figure 4). If you wish to use an aerosol cleaner, remove the grille first by gently pulling it away from the cabinet. The grille fabric may be cleaned with a normal clothes brush whilst the grille is detached from the cabinet. Avoid touching the drive unit diaphragms, especially the tweeter, as damage may result. [. . . ] The grille fabric may be cleaned with a normal clothes brush whilst the grille is detached from the cabinet. Avoid touching the drive unit diaphragms, especially the tweeter, as damage may result. [. . . ]