[. . . ] Projector
CP-X445
User Manual Operating Guide
Thank you for purchasing this projector. WARNING Before using, read the "User's Manual - Safety Guide" and these manuals to ensure correct usage through understanding. After reading, store them in a safe place for future reference.
About this manual
Various symbols are used in this manual. WARNING This symbol indicates information that , if ignored, could possibly result in personal injury or even death due to incorrect handling. [. . . ] · At a HDTV signal of 1125i (1080i) or 750p (720p) of COMPONENT VIDEO input, this item can't be selected. · Performing the automatic adjustment initializes the aspect ratio setting. Large (It reduces picture) Small (It magnifies picture) · This item can be selected only at a video signal. · When this adjustment is too large, certain degradation may appear at the frame area of the picture. Left Right This item is not selected when DVI-D input port is selected. Using the buttons / adjusts the horizontal phase to eliminate flicker. Right Left · This item can be selected only at a RGB signal or a component video signal. Note that this does not work with the input signal of 525i(480i)/625i(576i) from the component video port.
MENU[RGB]
:SELECT
ASPECT4:3 PICTURE OVERSCAN95 IMAGE VIDEOQlty. VPOSITION25 INPUT HPOSITION142 SETUP HPHASE16 SCREEN HSIZE1344 OPTION AUTOADJUSTEXECUTE NETWORK EASYMENU
ASPECT
OVER SCAN
V POSITION
H POSITION
H PHASE
29
Multifunctional settings
IMAGE Menu (continued)
Item Description Using the buttons / adjusts the horizontal size. Large Small · This item can be selected only at a RGB signal (except DVI-D). · When this adjustment is excessive, the picture may not be displayed correctly. In such a case, please reset the adjustment pressing the RESET button on the remote control during this operation. At a RGB signal The vertical position, the horizontal position, the clock phase and horizontal size will be automatically adjusted. Make sure that the application window is set to its maximum size prior to attempting to use this feature. At a video signal The video format best suited for the respective input signal will be selected automatically. This function is available only when the AUTO mode is selected to the item VIDEO FORMAT of INPUT menu. For a component video signal, the signal type is identified automatically independently of this function. · The automatic adjustment operation requires approximately 10 seconds. Also please note that it may not function correctly with some input.
H SIZE
AUTO ADJUST EXECUTE
30
Multifunctional settings
VIDEO Qlty. Select an item using the cursor buttons / on the projector or remote control, and press the cursor button on the projector or remote control, or the ENTER button on the remote control to progress. Then perform it referring to the following table.
Item Description Using the buttons / switches the progressive mode. TV FILM TURN OFF · This function performs only at an interlaced signal of a VIDEO input, a S-VIDEO input or a COMPONENT VIDEO input of 525i (480i) or 625i (576i) signal. [. . . ] After the projector has sufficiently cooled down, please make confirmation of the following items, and then turn the power on again. If the same indication is displayed after the treatment, please set the HIGH at the FAN SPEED of the item SERVICE of the OPTION menu.
Lighting In Green
Alternative blinking in Red
There is a possibility that the interior portion has become overcooled.
Please use the unit within the usage temperature parameters (5°C to 35°C). After the treatment, resent the power to ON.
It is time to clean the air filter.
Lighting In Green Simultaneous blinking in Red
Please immediately turn the power OFF, and clean or change the air filter by referring to the section "Air Filter". After cleaning or changed the air filter, please be sure to reset the filter timer. [. . . ]