[. . . ] W Open the door to an angle of about 45°, then tilt forwards until the hinge 7 is completely free and lift off. - If the appliance has a freezer compartment, now change the compartment door. [. . . ] W Place decor frames br/bu over panel and screw tight with retaining screws. W Cover screw heads with cover caps cl Equaliser trims for replacement appliances EK/EKB/EG * Depending on model and options 7 Installation instructions Installation information and dimensions W Fig. The shelf and side walls of the unit must be at right-angles to one another. W The following ventilation gaps must be observed: - The depth of the ventilation channel at the rear of the unit must be at least 38 mm. - There must be a ventilation space of at least 200 cm2 underneath and at the top of the unit. The following principle applies: the greater the area the more economically the appliance will run. D: appliance height (carcass) a, door height b, recess height c. (mm) a 872 1218 b 887 1233 c 874- 880 1220-1226 110 in. 2100 560570 1 mi 38 n. 557 593 54 90 2 Connecting to the mains Power supply (AC) and voltage at the operating point must comply with the details on the type plate. W The appliance must be connected with a properly installed fused socket. W The fuse of the plug has to be 10A or more, it must be situated away from the rear area of the appliance and be easily accessible. W Do not - connect to stand-alone inverters, - operate with so-called energy-saving plugs - this can damage the electronic system. - connect together with other appliances using an extension cable - danger of overheating. [. . . ] F, and align so it is flush with the front edge of the unit floor, fig. W Fasten/fix the appliance in the recess using chipboard screws dp/dq: through top hinge, pressing the appliance firmly against the unit wall; at the bottom through sleeve dr in the hinge 8 and plastic bracket ds - If necessary, align the equaliser trim dl by moving it parallel to the ceiling of the unit - it must not be proud, fig. [. . . ]