[. . . ] To change a fuse in this type of plug proceed as follows: 1 Remove fuse cover and fuse. If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place. if the mains plug contains a fuse , this should have a value of 5 Amp. If a plug without a fuse is used, the fuse at the distribution board should not be greater than 5 Amp. [. . . ] The receiver switches to STEREO and surround sound will be reduced to a stereo signal which is reproducible by standard headphones. If you wish to enjoy surround sound again, switch the receiver back to surround sound. Do not expose the receiver to humidity, rain, sand or excessive heat (caused by heating equipment or direct sunlight). The display of the receiver is divided into 4 sections, which are to be used for the following: Speaker diagram Signs showing you various settings and information about the status of the receiver. Incoming multi channel signals are being reduced to fewer output signals (depending on the number of speakers). Optical digital input OPTICAL IN is being used for the playing source (FR 965 only). Optical digital input OPTICAL 1 IN is being used for the playing source (FR 975 only). FRONT SIZE Left and right front speakers: small/large CENTER SIZE Center speaker: small/large REAR SIZE Rear speakers: small/large * SPK DISTANCE Distance between the usual listening position and the speakers. * SELECT INPUT Assigns the audio input connectors to the different source selections chosen with SOURCE SELECTOR (see "SOURCE SELECTION" for details). If the receiver is connected to a Philips CINEMA LINK TV via the CINEMA LINK system control bus sockets (see "CONNECTIONS"), you may use the TV to set up the system. Press CINEMA LINK to switch the connection between the receiver and the TV either on or off. If CINEMA LINK is switched on and the TV menu is active, TV MENU is displayed and the menu and sound functions on the receiver are locked. When selecting a source by turning SOURCE SELECTOR, the audio and video inputs with the corresponding name are activated. the incoming signal is reproduced by all audio and ­ if the source includes a video signal ­ video outputs of the receiver. It is possible to reassign a source selection to other than these standard inputs. Using one source selection for two or more appliances You may assign more than one source to a source selection. This can be useful when products are connected one after the other in a chain. example: A VCR is connected to the TV but only the TV is connected to the receiver. Both SOURCE SELECTOR settings, TV as well as VCR, have to use the TV input connectors. 3 Turn X MENU NAVIGATOR to select the input connectors which should be used (e. The 6 CHANNEL / DVD INPUT connectors can be assigned to any of the available sources (excluding TUNER and PHONO). The 6 CHANNEL / DVD INPUT can be used to connect a device with a built-in multichannel decoder (e. [. . . ] If you are receiving an RDS station, R and the station name are displayed. switching through different RDS information · Press RADIO TEXT on the receiver repeatedly to switch through the following information (if available): ­ Radio text messages ­ RDS clock ­ Frequency ­ Station name Note: The time signal broadcasted from certain RDS stations may not always be accurate. It is possible to set up the tuner in such a way that any playback is interrupted by news or traffic information of a chosen RDS station. Announcement functions only work if the necessary RDS signals are being broadcast. [. . . ]