[. . . ] Note: Before using thecan only be used be must without a parallel cable being Note: The OkiLan 6130 parallel port, you used remove the OkiLAN 6130 from the printer--see your connected. [. . . ] Then, if you wish to change the IP address, Subnet Mask and Default Gateway, you may do so. The Print Server will automatically be reset at this point, and your options will have been saved. (If you have network configuration questions, please contact your network administrator. Using Your Print Server's Built-In Web Page to Configure Your IP Address (Alternate Method) First, open your browser. Then, type the IP address of your Print Server into the browser's address bar. (If the IP address is unknown, you can obtain it by pressing and holding the Test Button on the front of the OkiLAN 6130 for five seconds) Then, if you wish to change the IP address, Subnet Mask and Default Gateway, you may do so. The Print Server will automatically be reset at this point, and your options will have been saved. (If you have network configuration questions, please contact your network administrator. [. . . ] Insert the OkiLAN 6130 by sliding it along the rails in the recess of the printer, until it is 5. [. . . ]