[. . . ] Operating Instructions
Advanta Series G 2170 Inspira Series G 1180 G 2180
To prevent accidents and machine damage read these instructions before installation or use.
en - US, CA
M. -Nr. 53
3
IMPORTANT SAFETY INSTRUCTIONS WARNING
When using your dishwasher, follow basic precautions, including the following: Read all instructions before installation or use of the dishwasher to prevent injury and machine damage.
Electrical Safety
~ Before installation, make sure that
the voltage and frequency listed on the data plate correspond with the household electrical supply. Consult a qualified electrician if in doubt.
~ Before installation or service,
disconnect the power supply to the work area by unplugging the unit, "tripping" the circuit breaker or removing the fuse.
The manufacturer cannot be held responsible for damage or injury caused by improper use of this appliance. Keep these operating instructions in a safe place and pass them on to any future user.
~ Do not use an extension cord to
connect this appliance to electricity. [. . . ] If a program has already started and you wish to change it: ^ Open the door. The program starts.
27
Additional functions
Buzzer
The end of a program and faults can be announced by a buzzer tone. The buzzer at the end of a program sounds five times in intervals with a brief break in between. The buzzer sounds for up to two minutes if the dishwasher is not turned off or the fault is fixed. ^ Press the program button and at the same time turn the dishwasher on g. Hold the program button until the lower right program indicator comes on. The upper right program indicator shows if the program end buzzer is turned on or off. Upper right program indicator flashes: Buzzer is turned on Upper right program indicator is off: Buzzer is turned off ^ To change the setting, press the program button until the "Intake/Drain" indicator lights. ^ Turn the dishwasher off o.
28
Additional functions
Factory default
All settings can be reset to the factory default. ^ Press the program button and at the same time turn the dishwasher on g. Hold the program button until the lower right program indicator comes on. The "Intake/Drain" indicator flashes once long and twice short in intervals. The upper right program indicator flashes: All settings are the factory default. The upper right program indicator is off: At least one setting was changed. ^ To change the setting, press the program button until the "Intake/Drain" indicator lights. ^ Turn the dishwasher off o.
29
Frequently asked questions
With the aid of the following guide, minor problems can be fixed without a service call.
, Repairs should only be carried out by a qualified and trained person in accordance with local and national safety regulations. Unauthorized repairs could cause personal injury or machine damage.
Technical faults
Issue The program does not start. Make sure it is a 15 A breaker.
The dishwasher stops during a program.
The dishwasher is not turned on. The fuse has tripped.
30
Frequently asked questions
Issue The buzzer sounds. Call Miele Technical Service.
The drain pump is The waterproof system running when the door has activated. is open.
31
Frequently asked questions
Problems water intake/drain
Issue Shortly after the program start the program stops. The "Intake/Drain" indicator flashes and lights alternately when the door is open. [. . . ] The manufacturer cannot be held responsible for unauthorized work.
Check that the voltage, frequency and fuse rating shown on the data plate match the household mains supply. A damaged power cord must only be replaced with a genuine Miele cord by a Miele service technician. In the event of a malfunction or breakdown, grounding will reduce the risk of electric shock by providing a path of least resistance for the electrical current. This appliance is equipped with a cord having an equipment grounding conductor and a grounding plug. [. . . ]