[. . . ] If the TV responds as it should to all of the key commands the SRU 3010 is ready for use. If the TV does not respond at all or not to all of the key commands, follow the instructions under `Setting the remote control', or for online setup go to: www. If that is the case, the SRU 3010 does not recognize the brand and/or model of your TV and you need to program the remote control to do so. [. . . ] Automatically setting the remote control The remote control will now automatically search for the right code for your device. 1 Make sure the TV is switched on and select a channel using the original remote control or the keys on the TV (for example channel 1). The SRU 3010 emits the `switch off TV' signal for all models of TV that are stored in the memory. 2 Then keep keys 1 and 3 on the SRU 3010 pressed simultaneously for three seconds, until the LED flashes twice and then remains lit. The SRU 3010 now starts emitting all known `TV off ' signals, one by one. Each time a code is sent, the LED lights up When your TV switches off (stand-by), release the Standby key of the SRU 3010 immediately. After the SRU 3010 has run through all the known codes, the search will stop automatically and the LED will stop flashing. 2 Look up the brand of your TV in the code list at the back of this manual. Point the SRU 3010 at the device and make sure that there are no obstructions between the SRU 3010 and the device. Try programming the RU 5010 again using another code, which is mentioned under the brand of your device, or reset for automatic search to find the right code. If you have any questions about the SRU 3010, you can always contact us. You will find our contact details after the code list at the back of this manual. If you cannot find any answers to your problems, write down the details of your device shown in the code list at the back of this manual. Look up the numbers of the models in the instructions accompanying the device or on the back of your device. When you call our helpline, make sure the device is to hand so that our operators can help you determine whether your remote control is working properly. The model number of your Philips universal remote control is SRU 3010/86. [. . . ] When you call our helpline, make sure the device is to hand so that our operators can help you determine whether your remote control is working properly. The model number of your Philips universal remote control is SRU 3010/86. Om du vill lägga till en funktion till SRU 3010, kan du ringa Philips kundtjånsten för universalfjärrkontroller och be om den 5-siffriga koden för extrafunktionen. [. . . ]