[. . . ] To install the oven under the counter (see diagram) and in a kitchen unit, the cabinet must have the following dimensions:
560 mm
.
45 m
m.
Centring and fastening Position the 4 tabs on the side of the oven according to the 4 holes of the outer frame. Adjust the tabs according to the thickness of the cabinet side panel, as shown below: thickness of 20 mm: take off the removable part of the tab (see diagram)
thickness of 18 mm: use the first groove, which has already been set in the factory (see diagram)
23 mm.
593 mm.
45 m
567 mm.
m.
mm
595 mm.
558
.
thickness of 16 mm: use the second groove (see diagram)
595
5 mm.
mm
.
545 .
mm
.
24
mm
!The appliance must not come into contact with electrical parts once it has been installed. The consumption indications on the data plate have been calculated for this type of installation.
Secure the appliance to the cabinet by opening the oven door and putting 4 screws into the 4 holes of the outer frame. [. . . ] When the selected time has elapsed, a buzzer sounds and the oven turns off. To use the oven manually, in other words when you do not wish to use the end of cooking timer, turn the COOKING TIMER knob until it reaches the 9 symbol.
* Only on certain models
16
Analogue programmer
Programming your cooking
Programming instant cooking time
12
GB
9
6
3
Setting the time
Press the PROGRAMMER knob and turn it anticlockwise to set the correct time. In case of a power failure, the PROGRAMMER will stop: the correct time will have to be reset.
1. Turn the PROGRAMMER knob anticlockwise until the desired cooking time is displayed. Pull the PROGRAMMER knob and turn it anticlockwise until the knob marker lines up with the current time. The oven comes on immediately and stays on for the entire duration of the set cooking time. When the selected time has elapsed, a buzzer will sound and the oven will turn off. Turn the PROGRAMMER knob anticlockwise until the desired cooking time is displayed. Pull the PROGRAMMER knob and turn it anticlockwise until the knob marker lines up with the desired cooking start time. The oven will come on at the set cooking start time and will stay on for the entire duration of the set cooking time. When the selected time has elapsed, a buzzer will sound and the oven will turn off. and a time of 1 hour and 15 minutes is programmed and the start time is set to 11:00. To cancel programming, turn the PROGRAMMER knob anticlockwise until the symbol 9 is displayed.
Starting the oven
1. Turn the PROGRAMMER knob anticlockwise until the 9 symbol is displayed. Pull the PROGRAMMER knob and turn it anticlockwise until the knob marker lines up with the current time. To turn the oven off, set the SELECTOR knob back to the 0 position.
17
Cooking modes
GB
Cooking modes
!A temperature value can be set for all cooking modes between 60°C and Max, except for BARBECUE (recommended: set only to MAX power level); GRATIN (recommended: do not exceed 200°C). TRADITIONAL OVEN mode Both the top and bottom heating elements will come on. With this traditional cooking mode, it is best to use one cooking rack only: if more than one rack is used, the heat will be distributed unevenly. MULTI-COOKING mode All the heating elements (top, bottom and circular), as well as the fan, will come on. Since the heat remains constant throughout the oven, the air cooks and browns food uniformly. The high and direct temperature of the grill is recommended for food that requires high surface temperature. [. . . ] Lift up and turn the small levers located on the two hinges (see diagram). Replace the screws A with the screws and spacers (B + C) supplied with the kit. Grip the door on the two external sides and close it approximately half way. Unlock the door by pressing on the clamps F, then pull the door towards you lifting it out of its seat (see diagram). [. . . ]