[. . . ]
6WDUW
$ % &
5HVHW VHF
en
Table of contents
Intensive zone . 17 17 17 17 17 17 18 18 18 18 19 19 19 19 19 20 20 20 20 21 21 22 22 23 23 23 24 24 25 25 25 26 26 26 26 26 27 27 27 28 28 28 28 28
Safety instructions . 17
en Safety instructions
Before you switch ON the appliance
Please read the operating and installation instructions carefully. They contain important information on how to install, use and maintain the appliance. [. . . ] – Press programme button # until the factory set value : is indicated on the digital display h. To change the setting: – By pressing the button 3, you can switch the function off : or on : . – Close the door.
* depending on model You can delay the start of the programme in 1-hour steps up to 24 hours. – Press P + or – button until the displayed time corresponds with your requirements. – To delete timer programming, press the P + or – button until h : is indicated on the digital display. You can change your programme selection at any time until the programme starts. – Close the door.
End of programme
The programme has ended when the value : is indicated on the numerical display h. – Hold down programme button # and press START button ` until : . . . . The LED for button # flashes and the digital display h displays the factory setting : . – Press programme button # until the factory set value : is indicated on the digital display h. Each time the button is pressed, the set value increases by one level; when the value of : has been reached, the display jumps back to : (off). – Close the door.
Remaining running time display
When the programme is selected, the remaining running time of the programme is indicated on the digital display h. The running time is determined during the programme by the water temperature, the number of utensils as well as the degree of soiling and may vary (depending on the selected programme).
18
en
Switching off automatically after the end of the programme *
myftelargeodfthnpar tncmta lfaSihgouw
Interrupting the programme
– Open the door. If the door was opened on an appliance which has a warm water connection or is heated, first leave the door ajar for several minutes and then close. Otherwise, expansion (pressure) may cause the appliance door to spring open or water to run out of the appliance. – To continue the programme, switch on the ON/OFF switch ( again. – Close the door.
nrem Tiatghpo
* depending on model To save energy, the dishwasher is switched off 1 minute after the programme ends (factory setting). Appliance does not switch off automatically : Off after 1 min : Off after 120 min – Open the door. – Hold down programme button # and press START button ` until : . . . The LED for button # flashes and the digital display h displays the factory setting : . – Press programme button # until the factory set value : is indicated on the digital display h. Each time the button is pressed, the set value increases by one level; when the value of : has been reached, the display jumps back to : (off). [. . . ] The hot water setting : allows you to adjust your appliance optimally to operation with hot water. It is recommended to have a water temperature (temperature of the incoming water) of at least 40 °C and no more than 60 °C. It is not recommended to connect the appliance to hot water if the water is supplied from an electric boiler. – Hold down programme button # and press START button ` until : . . . [. . . ]