[. . . ] Therefore, customers should purchase a Windows XP or Windows Vista software license and install the software. Do not install an illegal copy or a copy that has already been installed on another PC. For the installation procedures and any issues with the operating systems or applications not supplied by Samsung Computer, contact the corresponding software company. The company will not provide a replacement or refund due to the reason x, c and if our service engineer visits you due to this problem, a service charge will be applied. Charge the battery fully when using the computer for the first time. Before You Start Safety Precaution Notations Icon Notation Warning Caution Before reading the User Guide, first check the following information. Description Failing to follow instructions marked with this symbol, may cause personal injury and or fatality. [. . . ] Excessive RENs on the telephone line may result in the devices not ringing in response to an incoming call. In most, but not all areas, the sum of RENs should not exceed five (5. 0). To be certain of the number of devices that may be connected to a line, as determined by total RENs, contact the local telephone company to determine the maximum REN for the calling area. If the terminal equipment causes harm to the telephone network, the Telephone Company will notify you in advance that temporary discontinuance of service may be required. But if advance notice is not practical, the telephone company will notify the customer as soon as possible. Also, you will be advised of your right to file a complaint with the FCC if you believe it is necessary. The telephone company may make changes in its facilities, equipment, operations, or procedures that could affect the operation of the equipment. If this happens, the telephone company will provide advanced notice in order for you to make necessary modifications to maintain uninterrupted service. If trouble is experienced with this equipment (Modem) for repair or warranty information, please contact your local distributor. If the equipment is causing harm to the telephone network, the telephone company may request that you disconnect the equipment until the problem is resolved. The user must use the accessories and cables supplied by the manufacturer to get optimum performance from the product. This equipment cannot be used on public coin phone service provided by the telephone company. The termination on an interface may consist of any combination of devices subject only to the requirement that the sum of the Ringer Equivalence Numbers of all the devices does not exceed 5. Telecommunications per DOC notice (for products fitted with an IC-compliant modem) The Industry Canada label identifies certified equipment. This certification means that the equipment meets certain telecommunications network protective, operation, and safety requirements. The Department does not guarantee the equipment will operate to the users' satisfaction. Before installing this equipment, users should make sure that it is permissible to be connected to the facilities of the local telecommunications company. The equipment must also be installed using an acceptable method of connection. In some cases, the inside wiring associated with a single-line individual service may be extended by means of a certified connector assembly. The customer should be aware that compliance with the above conditions may not prevent degradation of service in some situations. European Union European Union CE Marking and Compliance Notices Products intended for sale within the European Union are marked with the Conformité Européene (CE) Marking, which indicates compliance with the applicable Directives and European standards and amendments identified below. The following information is only applicable to systems labeled with the CE mark . European Directives This Information Technology Equipment has been tested and found to comply with the following European directives: EMC Directive 89/336/EEC with amending directives 92/31/EEC & 93/68/EEC as per ­ EN 55022 Class B ­ EN 61000-3-2 ­ EN 61000-3-3 ­ EN 55024 Low Voltage Directive (Safety) 73/23/EEC as per EN 60950(A1/A2/A3/A4/A11) Radio and Telecom Terminal Equipment Directive 1999/5/EC as per ­ CTR21 (if fitted with a modem device) ­ EN 300 328 (if fitted with a 2. 4 GHz band embedded wireless device) ­ EN 301 489-1 (if fitted with a 2. 4 GHz band embedded wireless device) ­ EN 301 489-17 (if fitted with a 2. 4 GHz band embedded wireless device) ­ EN 301 893 (if fitted with a 5 GHz band embedded wireless device) European Radio Approval Information [Finnish] Tämä tuote noudattaa EU-direktiivin 1999/5/EC määräyksiä. [French] Ce produit est conforme aux exigences de la Directive Européenne 1999/5/EC. [German] Dieses Produkt entspricht den Bestimmungen der Europäischen Richtlinie 1999/5/EC [Greek] 1999/5/C. [Icelandic] Þessi vara stenst reglugerð Evrópska Efnahags Bandalagsins númer 1999/5/EC [Italian] Questo prodotto è conforme alla Direttiva Europea 1999/5/EC. [. . . ] To connect to a WPA wireless network, you have to configure the settings according to the network connection environment. For detailed setting information, ask your network administrator. 1 Radio Specifications RF Band Supported Channels Device Standard Output Power 2. 4GHz, 5GHz Channels allowed per country. Transceiver MAX 10mW 11a mode : OFDM Modulation Scheme 11b mode : DSSS 11g mode : OFDM 11a mode** : MAX 54Mbps Data Rate (Mbps)* 11b mode : MAX 11Mbps 11g mode*** : MAX 54Mbps Antenna Type * ** *** Built-in Antenna The data rate may differ from the real data transmission rate. 11a mode is only supported when the device is connected to an IEEE 802. 11a device. [. . . ]