[. . . ] [. . . ] The names Raytheon and RTN are owned by the Raytheon Company. ST6001+ Control Unit Quick Reference Guide Basic operation Auto mode Entering Auto mode (Engaging the autopilot) Returning to Standby (Disengaging the autopilot) Track mode Entering Track mode (from Auto or Wind Vane mode) to enter Track mode then Making course changes 1° Course changes to port or or to accept new heading 10° Course changes to starboard Exiting Track mode Press or Returning to previous locked heading to accept heading Wind Vane mode Entering Wind Vane mode and then 1 sec Using AutoTack AutoTack to port and and AutoTack to starboard Exiting Wind Vane mode Press Default AutoTack = 100° or Autopilot adjustments Adjusting response level To make temporary changes: and Adjusting keypad and display lighting 1 sec Displaying data pages Press to: · show first data page · scroll through available data pages · return to previous mode Use -1 or +1 to adjust response level. Press disp to return to previous mode. Use disp to adjust lighting level. Wait 10 sec to return to previous mode. D5502-2 Compass calibration 1 Enter Seatrial Calibration 2 sec x2 2 Complete the compass deviation correction Start turning boat (see below) Turn boat in slow circles so: · boat's speed stays below 2 knots · each circle takes at least 2 minutes Autopilot heading Minimum of 2 circles Keep turning the boat until you see the DEVIATION screen 3 Align the autopilot heading a Coarse adjustment: If COG is available from GPS, press then fine tune manually (see below). to set autopilot heading to COG value, b Fine adjustment: If COG is not available (or after setting heading to COG), align autopilot heading manually: Autopilot heading or or Steering compass Adjust the autopilot heading so it shows the same value as the boat's steering compass Known heading 4 Save changes 2 sec To: · save deviation correction · save heading alignment · return to STANDBY mode D5476-1 Document number: 86062-1 (use with handbook: 81190-1) Date: 11 May 2001 [. . . ] [. . . ]