[. . . ] When the pump cycle has finished, turn the selector knob to the position where it was when the drying cycle was interrupted.
Water container indicator light
Indicates that the water container is full and needs to be emptied. The drying programme is automatically stopped.
13
BEFORE USING THE DRYER
• After unpacking please make sure that the dryer is undamaged. In case of doubt do not use the dryer but call a qualified technician or your retailer. Packaging material (plastic, etc. ) must be kept out of the reach of children as it constitutes a potential risk. [. . . ] sheets or similar).
Buzzer Pressing the button initiates a buzzer sound to signal at regular intervals, at the end of the drying cycle. Additional Programmes Airing The laundry will be aired during 30 minutes without heating. Time programme (20 to 60 minutes) To gently finish dry or dry single items. Suitable for all fabrics.
16
SELECTING DRYING TIME OR PROGRAMME AND OPTIONS
Time-steered dryer
1. Select the drying time and the options according to the table (see Programme Table). Options (if available) To select an option, press the corresponding button. The Start delay selector should be turned clockwise to the required time delay and the Start button pressed. The time delay can be changed at any time by simply turning the Start delay selector. Close the door and press the Start button again to continue the count-down. Gentle Reduces the drying temperature for delicate articles.
Buzzer Pressing the button initiates a buzzer sound to signal at regular intervals, at the end of the drying cycle. Additional Programme Airing The laundry will be aired during 20 minutes without heating.
STARTING AND COMPLETING THE PROGRAMME
1. Having selected the desired drying time or programme and options, press the Start button. If you do not unload the laundry at the end of the drying cycle, an automatic anti-crease cycle will operate for maximum 20 min. (Electronic dryer): the drum rotates at regular intervals preventing the laundry from creasing. On completion of the programme, set the programme selector knob to position “0”. Clean the lint filter and empty the water container at the end of each drying cycle. If you change the programme (electronic dryer) during the drying cycle the dryer stops. 17
Interruption of the drying cycle
To interrupt the dryer during the drying cycle, set the programme selector knob to position ( ) Airing and press the Start button again for the Electronic dryer. Wait at least 5 minutes before opening the door to allow the dryer to cool down. For your safety the programme stops automatically if you open the door. To restart close the door and press the Start button again.
INSTALLATION
• • • • Install your dryer in a room which is not subject to extreme conditions. Should the room temperature rise above 35°C during the operation of the dryer, please ventilate the room. [. . . ] Lint filter or water container light on: • Is the lint filter clean?Has the pump position (Time-steered dryer) been selected (See “Water container” section)?
Waterdrops underneath the dryer: • Is the heat exchanger correctly positioned?• Has the fluff on the sealing of the heat exchanger been wiped away?Replacing inside light bulb (if available): • If the inside lamp does not work, the bulb may perhaps be faulty. [. . . ]