[. . . ] IFU Delta-Domino_LR-HR-STEAM-GB NEW. fm Page 1 Monday, September 15, 2008 3:59 PM
CONTENTS
DEFINITION OF USE BEFORE USING THE WASHING MACHINE PRECAUTIONS AND GENERAL RECOMMENDATIONS DESCRIPTION OF THE WASHING MACHINE DOOR CHILD SAFETY (IF AVAILABLE) BEFORE THE FIRST WASH CYCLE PREPARATION OF THE WASHING DETERGENTS AND ADDITIVES REMOVING THE FILTER/ DRAINING RESIDUAL WATER CARE AND MAINTENANCE TROUBLESHOOTING GUIDE AFTER-SALES SERVICE ACCESSORIES TRANSPORT/HANDLING ELECTRICAL CONNECTION
Black process 45. 0° 100. 0 LPI
IFU Delta-Domino_LR-HR-STEAM-GB NEW. fm Page 2 Monday, September 15, 2008 3:59 PM
DEFINITION OF USE
This washing machine is exclusively destined to wash machine washable laundry in quantities which are usual for private households. • Observe the instructions given in these Instructions for Use, the Installation Guide and the Programme Chart when using the washing machine. • Keep these Instructions for Use, the Programme Chart and the Installation Guide; if you pass on the washing machine to another person, also give him/her Instructions for Use, Programme Chart and Installation Guide.
BEFORE USING THE WASHING MACHINE
1. Removing the packaging and inspection
• After unpacking, make sure that the washing machine is undamaged. • Keep the packaging materials (plastic bags, polystyrene parts, etc. ) out of reach of children, as they are potentially dangerous. [. . . ] • Pour the starch solution prepared into the softener chamber while the water is running into the detergent dispenser.
3 1
How to position the separator in the main wash chamber for powder or liquid detergent
For use with powder detergent: place the separator in the higher position. Place its hooks on the upper end of the back guide rails and slightly push the separator down to fix it (fig. A gap should remain between the separator and the bottom of the main wash chamber, if the separator has been correctly installed (fig. For use with liquid detergent: place the separator in the lower position. Position the separator so that it touches the bottom of the main wash chamber (fig. GB 6
C
Black process 45. 0° 100. 0 LPI
}
Hooks
Guide Rails
2
IFU Delta-Domino_LR-HR-STEAM-GB NEW. fm Page 7 Monday, September 15, 2008 3:59 PM
REMOVING THE FILTER/ DRAINING RESIDUAL WATER
We recommend that you check and clean the filter regularly, at least two or three times a year.
A
Especially:
• If the appliance is not draining properly or if it fails to perform spin cycles. • If the “Clean filter” indication lights up: IMPORTANT: make sure the water has cooled before draining the appliance. Remove the plinth or open the cover (depending on the model) by using the separator of the detergent dispenser (fig. If your washing machine has the filter situated behind the plinth (see pictures “A” and “C”), use a broad and very flat container with a maximum height of 2 cm. Pour about 1 litre of water into the detergent drawer to reactivate the “Eco system”. The washing machine is now ready for operation again.
B
C
GB 7
Black process 45. 0° 100. 0 LPI
IFU Delta-Domino_LR-HR-STEAM-GB NEW. fm Page 8 Monday, September 15, 2008 3:59 PM
CARE AND MAINTENANCE
Appliance exterior and control panel
• Can be washed down with a soft, damp cloth. • Dry with a soft cloth.
Door seal
• Dry the door seal after each washing with an absorbent cotton cloth; make sure that the door seal is completely dry before closing the door of the empty washing machine. • Check the condition of the door seal periodically.
Appliance interior
• After each washing, leave the door open for some time to allow the inside of the appliance to dry. • If you never or seldom wash your laundry at 95°C, we recommend to occasionally run a 95°C programme without laundry, adding a small amount of detergent, to keep the interior of the appliance clean.
Filter
• Check and clean the filter regularly, at least two or three times a year (see “Removing The Filter/ Draining Residual Water”).
Water supply hose(s)
• Check the hose(s) regularly for brittleness and cracks. • Regularly check and clean the mesh filter inside the inlet hose (see “Cleaning the mesh filter in the water supply hose(s)”).
Do not use flammable fluids for cleaning the appliance.
Detergent dispenser
We recommend that you check and clean the detergent dispenser regularly. Press the release lever in the main wash chamber (see downward arrow) and remove the dispenser drawer from the dispenser compartment. Remove the separator from the main wash chamber by pulling it upward (see upward arrows). Refit the separator and the cover grid in the dispenser drawer and push the drawer back into the dispenser compartment.
GB 8
Black process 45. 0° 100. 0 LPI
IFU Delta-Domino_LR-HR-STEAM-GB NEW. fm Page 9 Monday, September 15, 2008 3:59 PM
Water supply hose(s)
If a supply hose shows a damage, replace it by a new hose of the same type, available through our After-Sales Service or your specialist dealer. “C”), periodically check the colour of the transparent coating. If the transparent hose coating turns into an intense red, this is an indication that the hose may have a leak and should be replaced. Contact our After-Sales Service team or specialist dealer to obtain a replacement hose.
A
Cleaning the mesh filter in the water supply hose(s)
1. Clean the internal mesh filter and screw the water inlet hose back onto the tap. [. . . ] Switch off the appliance (by pressing the “On/Off” button or by turning the programme selector to the “Off/O” position - depending on the model) and then switch it on again, select “Drain” and start within 15 sec. “Waterstop fault” Switch off the appliance the appliance (by pressing the “On/Off” button or by turning the programme selector to the “Off/O” position - depending on the model), pull out mains plug and turn the water tap off. Tilt the appliance forward carefully to allow collected water to flow out from the bottom. • Turn the water tap on (if water immediately flows into the appliance without the appliance being started, there is a failure; turn off the tap and notify the After-Sales Service). [. . . ]