[. . . ] When scrapping, follow the local disposal regulations for safeguarding the environment. To avoid the risk of children being Declaration of conformity This appliance is designed to store food and is manufactured in conformity with European directive No. This appliance is designed, manufactured, and retailed in compliance with: trapped and therefore suffocating, do not allow them to play or hide inside the refrigerator. Before scrapping, make the refrigerator unusable by removing the doors and cutting the power cable off. [. . . ] The glass shelves are strong enough to hold bottles, milk cartons and heavy food; nonetheless, avoid banging these down on the shelves. To remove the shelves: Slide the shelf out until it stops, then lift it up and remove it. Removal of the fruit and vegetable drawer or the meat drawer: Slide the drawer out until it stops; With one hand underneath the drawer, lift it and pull it out; The drawer will come out of its runners and can be pulled out further; To remove completely, the drawer will need to be rotated: front end up, back end down. To remove the glass cover of the drawer Lift the front of the frame 10 cm, then with your other hand, lift the back of the frame and pull it out. To replace the glass cover of the drawer Insert the back of the frame in the supports on the refrigerator walls and lower it back into place. Meat drawer temperature control The cold air flows into the meat drawer through an opening between the refrigerator and the freezer compartment. In this way the temperature inside the meat drawer is lower than in other parts of the refrigerator. If you wish to store vegetables in the meat drawer, move the control all the way to the left to the vegetables setting. For crushed ice, press the crushed ice button until the symbol lights up. Hold the glass close to the dispenser opening so ice does not fall outside of the glass. 3. You do not need to apply a lot of pressure to the lever in order to activate the ice dispenser. NOTE: The lock feature does not shut off power to the appliance, to the ice maker or to the light. It simply deactivates the dispenser levers.
3gb33009. fm5 Page 43 Monday, March 4, 2002 4:51 PM
AUTOMATIC ICE MAKER
Useful hints on the automatic ice maker To turn the ice maker on/off, press the On/Off button . If the freezer compartment door is open, make sure the inside flap is not blocked as it serves as lock sensor that shuts off the transfer of ice from the automatic ice maker into the bucket installed in the door. To remove and replace the ice bucket: 1. Place four fingers in bucket base opening and rest thumb on the release button. Holding the base of the bucket with both hands, press the release button and lift the bucket up and out. It is not necessary to turn the ice maker control to the OFF position. The ice maker will not produce ice without the bucket installed in the door. Normal Ice Production should produce approximately 7 to 9 batches of ice in a 24-hour period. 2. Wash the ice bucket with a mild detergent, rinse well and dry thoroughly. Do not use harsh or abrasive cleaners or solvents.
NOTE: Do not turn the ice maker on until it is connected to the water supply. The ice maker will not operate until the freezer compartment is cold enough to make ice. [. . . ] If the room is very humid, it is normal for moisture to build up inside the refrigerator. It is normal for droplets of water to form on the back wall after the automatic defrost cycle. If the doors do not open and close properly Check that food packages are not blocking the door. Check that the pans, shelves, drawers and ice maker are all positioned correctly. [. . . ]