[. . . ] Installation Stability: When installing the dryer always carefully level the dryer adjusting the four feet and check the correct levelling with a spirit level. To built in the dryer Remove the work-top and replace it with the BuiltIn kit UBS 10 (according to Eec Electrical Regulations), available at your dealer. Stacking kit Your dryer can be stacked on top of your front loading washing machine. The type of stacking kit is stated in the Instruction for use of your washing machine or pls. [. . . ] If necessary, the power cable may be replaced with an identical one obtained from our After-Sales Service. The power cable must only be replaced by a qualified technician.
The packing box may be fully recycled as confirmed by the recycling symbol . Energy saving tips Always dry a full load: depending on the type of laundry and the programme/drying time. By preference use the maximum spin speed allowed by your washing machine, since draining the water mechanically requires less energy. Place your dryer in a room with a temperature between 15° C and 20° C. Always select the correct programme/drying time for the load in order to obtain the desired drying results. When drying cotton, for example dry iron dry and cupboard dry loads together. Start with the iron dry programme/drying time setting, remove the laundry to be ironed at the end of that cycle and dry the remainder of the load on the cupboard dry setting. Disposing of packaging and old Dryer: The dryer is built from reusable materials. The dryer must be disposed of in compliance with local waste disposal regulations. Before scrapping, cut off the power cable so that the dryer cannot be connected to the mains. Child safety: Children must not be allowed to play with the dryer.
EC Declaration of Conformity This dryer has been designed, constructed and distributed in compliance with the safety requirements of EC Directives: 73/23/EEC Low Voltage Directive 89/336/EEC EMC Directive 93/68/EEC CE Marking Directive.
The dryer must only be used in the household for the prescribed uses.
13
DESCRIPTION OF THE DRYER
A. Heat exchanger.
A B2 G C F E D
H B1
Reminder - Maintenance and Cleaning
Clean the lint filter at the end of every drying cycle. Open the door Pull the filter upwards Open the filter Remove lint using a soft brush or your fingertips Close the filter Push the filter back into place.
Heat exchanger
Clean the heat exchanger at least every 3 months (See “HEAT EXCHANGER” chapter). Wipe away any lint/fluff from the door seal and interior using a damp cloth.
14
DRAINAGE SYSTEM
For water container top only To avoid having to empty the water container at the end of each cycle, the condensation water can be drained away. Note: Normally the drain hose is not supplied; the accessory AMH 883 kit, available at your dealer or our After Sales Service, should be used. Remove the hose located at the lower rear part of the dryer and insert it in the nearby hole. The height difference between the two drainage connections should not exceed 1m. Notice: To avoid siphoning, the end of the hose must not be immersed in the drain water. Avoid bending and twisting the hose.
B
C
15
DOOR REVERSIBILITY / CHILD SAFETY LOCK
Door Reversibility
A. Using a spanner, turn the contact pin in the upper part of the door by 90° and remove it.
C
D. Removing the door lock: Unscrew the 2 screws above and below the door lock system. [. . . ] Was the inserted laundry too wet (Washing machine spin speed less than 800 rpm?When the spinning speed is less than 800 rpm the water container fault may occur during the drying cycle)?(refer to the Instructions for use) Is the ambient temperature too high? Does “END” and “Anti-Crease” LED’s are lights up? [. . . ]