[. . . ] Installation • Do not install your dryer where it can be subject to extreme conditions, such as: poor ventilation, temperatures around freezing (or above 35°C). Stability: When installing the dryer always carefully level the dryer adjusting the two feet and check the correct levelling with a spirit level. To built in the dryer • For security reasons do not remove the worktop. [. . . ] Always select the correct programme/drying time for the load in order to obtain the desired drying results. When drying cotton, for example: dry iron dry and cupboard dry loads together. Start with the iron dry programme/drying time setting, remove the laundry to be ironed at the end of that cycle and dry the remainder of the load on the cupboard dry setting. The dryer must be disposed of in compliance with local waste disposal regulations. Before scrapping, cut off the power cable so that the dryer cannot be connected to the mains. General recommendations: Always set the programme/time selector knob to the “0” position after use. Before cleaning or carrying out maintenance, switch off the dryer and disconnect it from the mains supply. To clean the outside of the dryer, use a neutral detergent and a damp cloth. If the lint filter mesh is clogged, clean it with water and a soft brush. If necessary, the power cable may be replaced with an identical one obtained from our After-Sales Service. The power cable must only be replaced by a qualified technician.
2.
EC Declaration of Conformity This dryer has been designed, constructed and distributed in compliance with the safety requirements of EC Directives: 73/23/EEC Low Voltage Directive 89/336/EEC EMC Directive • 93/68/EEC CE Marking Directive.
3.
The dryer must be used in the household for the described uses.
4.
5. Door To open the door: pull the handle To close the door: push gently until closed. Filter
A
B C
D
Reminder - Maintenance and Cleaning
Clean the lint filter at the end of every drying cycle: Open the door. Remove lint using a soft brush or your fingertips.
7
VENT CONNECTION
Normally the hose and adaptor are not supplied; the accessory AMH 577 kit, available at your dealer or our After Sales Service, should be used.
Installing the vent hose
A. Place a towel or the packing material on the right-hand side next to the dryer. Place the dryer on its right-hand side (seen from the front) on the towel or the packing material. Attach the air vent hose adapter to the connection located under the dryer and lock it by means of the foreseen lugs.
Venting outside Without kinking it, lead the vent hose outside (inside diameter 10 cm, maximum length with two bends 3 m). [. . . ] Insert the door lock system on the opposite side and lock it securely. Replace the contact pin in the inside of the door (top).
E
F E
9
TROUBLESHOOTING GUIDE / AFTER-SALES SERVICE
Troubleshooting Guide If a fault occurs, before contacting our AfterSales Service, make the following checks to try and remedy the problem: Drying takes too long / laundry is not dry enough:
Was the correct programme selected?Was the inserted laundry too wet (Washing machine spin speed less than 800 rpm)? [. . . ]