[. . . ] GB
AWT 2240/ AWT 2250
Cold Machine Off No Spin Programme duration figures (guideline) are valid for maximum temperature wash with no special functions.
❉ : option / Yes: dosing required
1) Do not use liquid detergents. 2) Max 400 rpm for AWT 2240
Max 500 rpm for AWT 2250 Temperature Selector
Max. [. . . ] Please avoid excessive detergent dosing.
Whirlpool is a registered trademark of Whirlpool USA.
5019 312 10057
Programme
ENERGY AND WATER CONSUMPTION DATA Temperature Load Water (°C) 90 60 60 40 40 30 40 40 (kg) 5. 0 5. 0 2. 0 2. 0 2. 5 1. 0 1. 5 1. 0 (l) 72 72 66 66 54 54 70 70
PROGRAMME END Energy (kWh) 1. 80 1. 15 0. 80 0. 40 0. 50 0. 30 0. 65 0. 55 Programme time (min) 115 115 100 100 85 70 55 45 1. Open the door and the drum flaps and unload the machine.
TO STOP, RESET A PROGRAMME BEFORE THE END 1. Turn the spin speed knob to the Off position to switch off the appliance. Turn the spin speed knob to the desired spin speed to start the Drain programme. Only open the door when the programme selector is at STOP and the door is unlocked (after approximately 1 minute). NOTES AND INDICATIONS FOR USE After switching your washing machine on, it does not start immediately: it needs some seconds in order to lock the door, fill water and then drum starts turning. Spinning has an interrupted start-up: the drum starts and stops running several times, to improve spin efficiency and to better balance the laundry. At the end of the spinning cycle the drum goes on reversing for some minutes: this helps you unloading the laundry. Do not exceed in detergents dosage: excessive foam formation may prevent spinning.
Cotton Cotton Coloured Coloured Quick Wash + 1/2 Load Synthetics + 1/2 Load Delicate Wool
SELECTING A NEW PROGRAMME, SPIN SPEED, OPTIONS AFTER PROGRAMME START 1. Turn the spin speed knob to the Off position to switch off the appliance. Turn the spin speed knob to the desired spin speed to switch on the appliance. The pilot light lights.
Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized conditions in compliance with standard IEC 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. [. . . ] PROGRAMME START Open the water inlet tap and select the desired spin speed, turning the spin speed and On/Off knob to the desired position (the indicated spin speed or No Spin). If the programme is stopped or if an electrical power failure occurs, the door unlocks automatically after about 1 minute.
Whirlpool is a registered trademark of Whirlpool USA.
5019 312 10057 [. . . ]