[. . . ] Verify the stated icons on the identification label on the fitting and the icons that are shown in part A of your safety instructions. Disposal of your old product: Your product is designed and manufactured with high quality materials and components, which can be recycled and reused. [. . . ] 20- Protection class II: the fitting is double insulated and must not be connected to an Earth. 21- Protection class III: the fitting is only suitable for very low voltage supply (e. 23- The earthing wire always has to be longer than the contact wires. 24- The use of the supplied heat-resistant sleeving is required over the unstripped wire lengths. 27- X-connection: In case of damage to the wire, it has to be replaced by a wire of the same type. Y-connection: In case of damage to the wire, it has to be replaced only by the manufacturer, distributor or by an expert, to avoid risks. W: only use lamps suitable for this fitting and keep within the maximum specified wattage. 33- Only use an incandescent globe bulb that is the size of the indicated diameter. 36- The fitting is only suitable for a lamp with built-in safety or a low pressure lamp. If the fitting is out of order after the bulb has been replaced, the internal fuse has to be replaced. If contact with the internal wiring can be made during this operation, this should be done by a competent electrician. 39- The fitting can be used in combination with a dimmer with exception where PLCE-lamps are used. [. . . ] The guarantee is void if the fitting was not installed following the instructions or repaired or modified. The manufacturer does not accept any liability for damage caused as a result of misuse or wrong application of the fitting. [. . . ]