[. . . ] DC IN Jack (p17) Use this jack to power the camera/recorder from the AC adapter or from battery in your vehicle. 21. Sub Power Switch (p24) STANDBY: Pressing the Start/Stop button will start recording. LOCK: The camera/recorder will not enter the record mode even if the Start/Stop button is pressed. [. . . ] Hold down the DATE button for at least 3 seconds: The flashing cursor will appear at the date. Press the FF button repeatedly until the digit that is incorrect flashes. Correct the incorrect digit by using the PLAY, STOP and FF buttons. 4 CHARGING THE BATTERY The first step is to set the battery for charging. To charge the battery, attach it to the camera/recorder, and connect the VM-ACE5E AC adaptor. Charge the battery at a temperature range of 10 C ­ 30 C to prevent damage to the battery. NOTES: · This camera/recorder operates with a lithium ion battery such as VM-BPL13/VMBPL30/VM-BPL60. · We cannot be responsible for any malfunctions of the camera/recorder which occur when you use battery packs other than those specified. CHARGE Indicator To DC IN Jack AC Adaptor Charge the battery on a flat surface that is free of vibration. · Place the battery on the guide platform and slide it down so that it fits into the camera/recorder. NOTE: Always attach a battery only by the procedure described here. Connect the AC adaptor DC plug to the DC IN jack of the camera/recorder. CHARGE 5 indicator of the camera/recorder will flash or light to give you a reference of the charged level. CHARGE indicator flashes once every two seconds, the battery could be defective. CHARGE indicator will not light at all when the AC adaptor is defective. If the fully charged battery is removed and then re-attached, the camera/recorder will again enter the charge mode, and the BATT. It will take a few minutes for the camera/recorder to enter the charge complete status. After charging is complete, disconnect the AC adaptor DC plug from the camera/recorder. [. . . ] NOTE: The VM-H775LE menu displays are used for the following explanation. Some items do not appear, depending on the model. Menu selectable in the CAM mode When the MENU button is pressed, the following menu display will appear: To correct camera shake (p41). To record in optimum status to match tape being used (p23) (only for VM-H775LE). [. . . ]