[. . . ] With alternative plugs not incorporating a fuse, the circuit must be protected by a 15 Amp fuse. If the plug is a moulded-on type, the fuse cover must be re-fitted when changing the fuse using a 13 Amp Asta approved fuse to BS 1362. In the event of losing the fuse cover, the plug must NOT be used until a replacement fuse cover can be obtained from your nearest electrical dealer. [. . . ] · The power cable for this appliance must not be replaced by the user, in that this operation requires the use of special tools. In the event of damage, only contact a service centre authorised by the manufacturer so as to avoid any risks. SAFETY WARNINGS · This machine has been manufactured to "make coffee". Never use other extracts, cocoa powder, camomile, other infusions or soluble substances: these may block the holes in the filter. · During cleaning, never immerse the base and the boiler in water: this is an electrical appliance. · Be careful to avoid being scalded by spraying water or steam or due to the improper use of the appliance. · After having removed the packaging, check that the appliance is in tact. If in doubt, do not use the appliance and contact a professionally qualified person. · The parts of the packaging (plastic bags, polystyrene foam, etc. ) not must be left within the reach of children, as they are potential sources of danger. INSTALLATION · Place the appliance on a bench away from water taps and sinks. · Check that the voltage of the mains power supply corresponds to the value indicated on the appliance's rating plate. Only connect the appliance to a power outlet with a minimum rating of 6A that is properly earthed. The manufacturer declines all liability for any accidents caused if the system is not correctly earthed. · If the power outlet does not match the plug on the appliance, have the outlet replaced with a suitable type by qualified personnel. 7 HOW TO PREPARE THE COFFEE 1) Check that the coffee maker is cold, and then unscrew it by holding the boiler with one hand and turning the pitcher anticlockwise with the other (Fig. 2) Remove the funnel filter and, to prepare a full pot of coffee, fill the boiler with fresh water until reaching the safety valve (visible inside the boiler), without exceeding it (Fig. On the other hand, to prepare half a pot of coffee maker, fill the boiler with water to the circular mark under the safety valve (Fig. IMPORTANT: do not use the coffee maker without water in the boiler or alternatively using hot water for faster operation. When preparing half a pot, also place the adapter disk (L) into the funnel filter (Fig. 4) Fill the funnel filter with ground coffee, without pressing it (Fig. 5) Distribute the ground coffee uniformly and remove any excess coffee from the edge of the filter. [. . . ] In any case, once the coffee has brewed, the coffee maker can be switched off by pressing the on/off switch. CLEANING AND MAINTENANCE · Before performing the cleaning operations, wait for the coffee maker to have cooled down after use. · Regularly check the funnel and the gasket: replace if there are signs of wear or deterioration. · Every so often check that the holes in the disk filter are not blocked; if necessary, clean using a pin (Fig. [. . . ]