[. . . ] NOTE: The red SPEAKER LED will indicate that the speakerphone is active. Listen for dial tone, dial the desired number, or press an AUTO DIAL key to automatically dial a number. To end call the call press the SPEAKER key again.
RECEIVING A CALL
An audible ring and flickering red LED indicate an inbound call. 1
USING THE SPEAKERPHONE With the handset in the cradle, press the SPEAKER key. [. . . ] The number selected will be the new pause timing in seconds (ie: "3" = 3 seconds). Press the STORE key.
AUTO DIAL KEYS
The Opal 1010S has ten (10) programmable AUTO DIAL keys. These keys can be programmed to automatically dial telephone numbers, or activate telephone system features. PROGRAMMING AUTO DIAL KEYS: The telephone must be connected to a telephone line. Place the handset back in the cradle or press the SPEAKERPHONE key to disconnect.
4
CONVERTING FROM DESK TO W ALL MOUNT
The Opal 1010S can be changed for wall mounting applications. The conversion is easiest when the handset and line cords are not connected. Located on the top of the telephone above the speaker grill is the wall/ desk mount clip. Flip the clip over (top to bottom) so that the protruding edge is towards the top of the phone. Locate and remove the mounting bracket, firmly push back and pull up to remove two of the four retaining tabs. Rotate the mounting bracket 180 degrees clockwise so that the mounting eyelet on the bracket is facing in the same direction as the other mounting eyelet located on the bottom of the telephone. Insert the top two retaining tabs of the mounting brackets into the mounting bracket slots (located near the middle of the telephone). Then firmly push down to insert the retaining tabs on the opposite side of the mounting bracket. Connect a short modular line cord into the jack on the back of the phone (labeled LINE). Connect the other end of line cord to the phone jack on the wall mounting plate. Turn the telephone over, and slide the Opal 1010S down onto the mounting posts in downward direction. Complete the wall mounting by installing the handset and handset cord.
5
OPAL 1010S DIAGRAM
MESSAGE WAITING LIGHT RING VOLUME MODULAR PHONE LINE JACK
DATA PORT FLASH KEY (RECESSED) STORE KEY (RECESSED)
SPEAKER VOLUME AUTO DIAL KEYS
AUTO DIAL KEYS
HOLD
HANDSET VOLUME REDIAL
SPEAKER PHONE
MUTE
6
REQUIREMENTS OF PART 68 - FCC RULES
This device has been granted a registration number by the Federal Communications Commission, under Part 68 rules and regulations for direct connection to the telephone lines. In order to comply with these FCC rules, the following instructions must be carefully read and applicable portions followed completely: 1. Direct connection to the telephone lines may be made only through the standard modular cord furnished, to the utility installed jack. On the bottom of the phone is a label that contains among other information, the FCC Registration Number and the Ringer Equivalence number (REN) for this equipment. If requested this information must be provided to the telephone company. The telephone company, under certain circumstances, may temporarily discontinue and make changes in facilities and services which may affect the operation of the users' equipment: however, the user shall be given adequate notice in writing to allow the user to maintain uninterrupted service. In certain circumstances, it may be necessary for the telephone company to request information from you concerning the equipment which you have connected to your telephone line. [. . . ] INCORRECT REASSEMBLE CAN CAUSE ELECTRIC SHOCK WHEN THE APPLIANCE IS SUBSEQUENTLY USED. UNPLUG THIS PRODUCT FROM THE WALL OUTLET AND REFER SERVICING TO QUALIFIED SERVICE PERSONNEL UNDER THE FOLLOWING CONDITIONS. · WHEN THE POWER SUPPLY CORD OR PLUG IS DAMAGED OR FRAYED · IF LIQUID HAS BEEN SPILLED INTO THE PRODUCT. · IF THE PRODUCT DOES NOT OPERATE NORMALLY BY FOLLOWING THE OPERATING INSTRUCTIONS. [. . . ]