[. . . ] If the appliance is delivered in the winter months when there are minus temperatures: Store the washing machine at room temperature for 24 hours before using for the first time. Correct use The washing machine is only designed for the washing of normal domestic laundry at home. Use only detergents and additives that are suitable for use in domestic washing machines. Dyes/colour removers may only be used in the washing machine, if the manufacturer of these products expressly permits this. We cannot be held responsible for any damage arising. Safety of Children and Infirm Persons Keep packaging away from children. [. . . ] Clean all parts of the washing machine, especially the nozzles in the top of the washing-in chamber, with a brush. Insert the detergent dispenser drawer in the guide rails and push it in. Washing drum Rust deposits in the drum may occur due to rusting foreign bodies in the washing or tap water containing iron. Do not clean the drum with acidic descaling agents, scouring agents containing chlorine or iron or steel wool. Remove any rust deposits on the drum with a cleaning agent for stainless steel. Run a washing cycle without any washing to clean off any cleaning agent residues. 1/4 measuring cup of detergent. Door and rubber collar Regularly check whether deposits or foreign bodies are present in the folds of the rubber collar or on the inside of the glass door. Clean the glass in the door and the rubber collar regularly. 18 What to do if. . . Remedying small malfunctions If one of the following fault codes is displayed in the multi-display during operation: E10 (Problems with water inlet), E20 (Problems with water drainage), E40 (door open), please have a look at the following table. In the event of other faults (E plus a number or a letter): Switch the appliance off and on again. If the fault is displayed again, please contact the Customer Care Department and inform them of the fault code. Problem Possible cause Mains plug not plugged in or fuse not working. Make another selection. When a button is The selected function canpressed, Err appears in not be combined with the the multi-display. END display flashes 4x, at the same time an acoustic signal sounds 4x. It is only necessary to open the pump cover if there is a malfunction and water is no longer being pumped out, e. Please make sure before loading the washing that there are no foreign bodies in the pockets or caught between the washing. that may have got into the washing machine with the washing remain in the pump housing (foreign body trap that protects the pump wheel). 1 Warning!Before opening the pump cover, switch off the washing machine and remove the mains plug from the socket. Unscrew the pump cover in an anticlockwise direction and remove it. 4. Remove foreign bodies and fluff from the pump housing and from the pump wheel. 5. Check whether the pump wheel right at the back of the pump housing can turn. (It is normal for the pumping wheel to turn jerkily. ) If the pumping wheel cannot be turned, please contact the Customer Care Department. Insert the guides at the sides of the cover into the guide slots and tighten the cover by turning in a clockwise direction. 23 Disposal 2 Packaging material The packaging materials are environmentally friendly and can be recycled. Please dispose of the packaging materials in the appropriate container at the community waste disposal facilities. [. . . ] Angle the hose to the left or right depending on the position of your water tap. After positioning the inlet hose, be sure to tighten the ring nut again to prevent leaks. Installation should comply with local water authority and building regulations' requirements. A minimum water pressure of 0. 05 MPa (0. 5 bar) is required for safe operation of the appliance. [. . . ]