[. . . ] For future reference please keep this instruction booklet in a safe place.
CUSTOMER SERVICE AND GUARANTEE
Your new appliance is fully guaranteed by the manufacturer for 12 months against electrical/mechanical breakdown excluding: A. Any faults which occur due to bad installation or misuse of the machine. Any faults which occur due to repair of, or interference with, the machine by any person not authorised by the manufacturer to carry out service. Any faults which occur due to any parts which are fitted to the machine which are not the original manufacturers parts. [. . . ] If the machine comes open while it is working, an electrical safety device automatically switches everything off. IMPORTANT For the machine to work properly, the door should not be opened while it is in operation.
8
Closing the door
Place the baskets in the machine. Make sure that both the spray arms are free to rotate and are not obstructed by cutlery, crockery or pans. Close the door, pressing on it to make sure it is firmly shut.
0 1 *2 3 4
FREE N. 1 N. 2 N. 3 N. 4
9
Loading the salt
On the bottom of the machine there is a container for the salt for regenerating the softener. It is important to use only a salt that is specifically designed for dishwasher. Other types of salt contain small quantities of insoluble particles which over a long period of time may affect and deteriorate the softener performance. To add salt, unscrew the cap of the container on the bottom and then refill the container. During this operation a little water will overflow; but keep adding salt until the container is full. When the container is full, clean the thread of salt residue and retighten the tap. After loading the salt, it is recommended running a complete washing cycle, or COLD RINSE programme. The salt dispenser has a capacity of between 1. 5 and 1. 8 kg and, for efficient use of the appliance, it should be refilled from time to time according to the regulation of the water softener unit.
IMPORTANT (Only for first start up) When the appliance is used for the first time, after completely filling the salt container, it is necessary to add water until the container overflows.
Adjustment of the upper basket
If 27 cm to 31 cm plates are normally used, load them onto the lower basket after the upper basket has been placed in its upper position and proceed as detailed below: 1. We advise using 20:30 g of detergent in the wash section of detergent compartment (B).
Since not all detergents are the same the instructions on the boxes of detergent can vary. We should just like to remind users that too little detergent does not clean the dishes properly whilst too much detergent will not produce better results and is also a waste.
Filling the rinse aid container
The rinse aid, which is automatically released during the last rinsing cycle, helps the dishes to dry quickly and prevents spots and stains forming. The rinse aid container can be found to the left of the detergent container (fig. To open the lid, push the reference mark and, in the same time, pull the tab of opening. It is always advisable to use rinse aid that is specifically designed for dishwasher. Check the rinse aid level through the indicator eye (C) which is located on the dispenser.
C
IMPORTANT Do not use an excessive amount of detergent and help limit damage to the environment at the same time.
FULL
EMPTY
dark
light
CAUTION!IMPORTANT NOTE ON THE USE OF COMBINED DETERGENTS
Regulating the rinse aid from 1 to 6
The regulator (D) is placed under the lid and can be turned using a coin. The limestone content of the water considerably affects the formation of limescale and the drying performance. It is therefore important to regulate the quantity of rinse aid to achieve good washing results. If, after the wash, streaks occur on the dishes, decrease the amount by one position. If whitish spots occur, increase the amount by one position.
17
A
If you are planning to use combined detergents i. e. [. . . ] Press the "ON/OFF" button .
IMPORTANT To confirm the "COLD RINSE" program, simultaneously press the "RAPID" program button and the "HALF LOAD" option button (the relevant LEDs will stop blinking and remain on to confirm the selection).
After pressing the "ON/OFF" button, the LED for the factory set is "recommended" (which is ideal for full load daily use) or the LED for the "Auto' Memory" program (see below) will blink.
If the previously described operations were performed with the door open, the program will not start until the door is closed.
IMPORTANT The dishwasher has two very practical functions: ( the "recommended" program ) for quick and sure selection;
IMPORTANT To cancel the "COLD RINSE" program, simultaneously hold down the "RAPID" program button and "HALF LOAD" option button (the relevant LEDs will blink to confirm cancellation). At this point a new program can be set.
IMPORTANT This button MUST be set BEFORE the program starts.
Program interruption
Opening the door when a program is running is not recommended especially during the main washing and final hot rinse phases. However, if the door is opened while a program is running (for example, to add dishes) the machine stops automatically. The cycle will start from where it left off (if it is necessary, the appliance will make a short thermal anti-shock programme before).
Fault signals
If malfunctions or faults occur when a program is running the LED that corresponds to the selected cycle (2 LEDs for the "COLD RINSE" program) will blink rapidly. [. . . ]