[. . . ] OWNER’S MANUAL
Wall Mounting Bracket
Please read this manual carefully before operating your set and retain it for future reference.
LSW130B
P/NO : MFL63640533 (1212-REV00)
www. lg. com (Brazil : www. lge. com)
Component
Wall mount anchor 4 units
Wall mount screw 4 units
User manual
PVC Washer 4 units
Set protection cushion 4 units
Set screw M4 X 10 mm 4 units M4 X 14 mm 4 units
IMPORTANT SAFETY INSTRUCTIONS
Read these instructions. Follow all instructions.
Warning
This wall mount should be installed by a trained and experienced installer designated by the retailer.
Having the product installed by a non-specialized installer is very dangerous and can cause damage or injury.
Do not install the product where the weight cannot be supported.
If the strength of the location where the wall mount is installed is not strong enough, it can fall off and cause an injury.
Use a trained and experienced installer to move or replace the wall mount, if needed.
Installation requires special techniques and moving or installing the product on your own can cause serious safety issues.
After installing the wall mount, do not hang on the product or apply severe impact to the product.
The product can fall off and cause injury.
When installing the wall mount, never hang the power or signal cable on the rear side the TV.
The cord can be damaged and cause a fire, an electric shock or damage to the product.
2
Caution
Install the product according to the directions in the user manual.
If the product is not installed based on the directions in the user manual, it can cause a serious injury or damage to the product.
When installing the product or adjusting the height of the product after installing, always do so with 2 people.
Working alone can cause the product to fall off and result in injury or damage to the product.
During the installation, check the type of wall material and use the sealed anchor and screw if the conditions comply.
If you do not use the designated anchor or screw, the mount may not be able to withstand the weight of the product and cause a safety issue. [. . . ] * Be careful not to install a TV that exceeds the weight restrictions of the wall mount. * Be careful with the tools used during installation to prevent accidents or damage.
3
ENGLISH
Installation method
- Tools you will need : Phillips head "+" driver(Manual or motorized) Ø4 mm drill bit for wood or steel / Level / Stud finder / Drill. You may also need an 8 mm socket wrench or an Ø8 mm drill bit for concrete.
1
Separating the TV bracket
1 2
3
Safety pin
<Work procedure> 1. 3.
2
Attaching the mounting bracket on the TV
Make sure the screws are fully tightened to the bracket and display. If the screws will not fully tightened, they might be too long or the wrong size.
VESA 100X100 / VESA 200X100 is supported. If needed, you may refer to the display's user manual to verify the display has one of the supported VESA formats.
Screws are included for the following models: M4 X 10 mm : 9LED LCD TV/LCD TV/LED TV 1 22LED LCD TV/LCD TV/LED TV 24LN4*/26LN4*/28LN4*/29LN4* M4 X 14 mm : 6LED LCD TV/LCD TV/LED TV 2 32LED LCD TV/LCD TV/LED TV
Bracket to attach to the display
VESA 200 VESA 100
VESA 100
Install the PVC washer between the brackets and the display on the following models : 32LE46*/32LE53*/32LE55* But for 26LE53*/26LE55* model, this is provided as TV component.
<Work procedure> 1. Check to see if the display has screws already installed into the VESA mounting holes. Use a Phillips head "+" screwdriver to tighten the A screws. - Make sure the screws are fully tightened to the bracket and display.
4
- Use the anchors for wall material of concrete, light concrete, strong natural stone, soft natural stone masonry brick and hallow block that do not crack.
Please follow the below direction.
- Check the material of the wall and the thickness of the finishing. - hen installing the product on wall material not designated, install the product so that each fixated location W can withstand the pull out load of 70 kgf (686 N) and shear load of 100 kgf (980 N) or above. Anchor
a b c
Wall mount screw
d e
- Use the Ø8 mm drill bit for concrete and hammer (Impact) drill. Use a drill bit Ø8 mm to drill a hole for the anchor location within a depth of 80 mm - 100 mm. [. . . ] UL Load Capacity (kg)
LSW130B 221 152 14 0. 9 100 X 100/200 X 100 15
7
ENGLISH
The model and serial number of the product is located on the back or one side of the product. Record it below should you ever need service.
Supported Displays: (Please contract the retailers or refer to the TV owner’s manual for applicable models. )
MODEL SERIAL [. . . ]