[. . . ] EN Unpacking the Appliance EN Installing the access ramp of the station . 1 1 2 2 2 3 3 4 4 4 Dear Customer, Please read and comply with these original instructions prior to the initial operation of your appliance and store them for later use or subsequent owners. english
Proper use
The RoboCleaner consists of two units: a station and a battery-operated cleaning robot. ρ It is intended for the fully automated cleaning of the interior area and can be used on all common floor coverings for the autonomous, continuous routine cleaning. [. . . ] 0 25
EN – 7
Illustration Push the new filter bag all the way into the holder. Exchange the motor protection filter Illustration If you have replaced the filter bag 5 times, also exchange the motor protection filter (included in the spare filter bag kit). Illustration Reinsert the flat filter, the flaps should point toward the locking lever. Remove, clean, replace and install the brush roller Empty the dirt receptacle and open it (refer to the description above). ρ Remove the brush roller Illustration Pull the brush roller out of the right guide. ρ Cleaning the brush roller The dirty brush roller is automatically cleaned during each cleaning operation in the station. Illustration Use a pair of scissors to cut along the cutting edge of the brush roller. ρ Replacing the brush roller Replace the brush roller when its bristles are worn out. 0 Illustration Install the brush roller Insert the brush roller first into the left holder. σ Then press the brush roller into the right hand side holder with the hook facing down; ensure that it locks into place. Clean dust sensors Empty the dirt receptacle and open it (refer to the description above). Illustration Clean the dust sensors using a soft cloth or a soft paintbrush. Cleaning robot
Cleaning the wheels Clean the running surfaces of the wheels when these become dirty. ) can collect on the running surface and damage sensitive, smooth floor surfaces. Begin all maintenance work on the cleaning robot with the following steps: Empty the dirt receptacle; see Chapter "Start-up“. σ Opening the dirt receptacle: Rotate the cleaning robot and place it on a soft surface. Cleaning the flat filter Clean the flat filter in the cleaning robot every time you exchange the filter bag in the station. σ Empty the dirt receptacle and open it (refer to the description above). σ Shake out the flat filter, or clean it using a small soft brush. 26
EN – 8
Finish all maintenance work on the cleaning robot with the following steps: Installing the dirt receptacle cover: Illustration Put the cover onto the dirt receptacle. In addition, press on the front side of the cover to ensure the dirt receptacle is closed safely. Exchanging the batteries Illustration 28 Release the two screws on the two batteries, and remove the old batteries. [. . . ] You can lift the robot from the floor using both hands, or you carry it by putting one hand into the relief of the brush. You have to remove the filter from the robot and clean it (see Chapter "Cleaning flat filter“). The robot stops at this point and displays the signal for being stuck. If no more light is blinking, the batteries are depleted and must be recharged. [. . . ]