[. . . ] Note: Do not put perfume, vinegar, starch, descaling agents, ironing aids, chemically descaled water or other chemicals in the water tank. ¯2) 2 Fill the water tank up to the MAX indicationâ¯(Fig. [. . . ] Storage 1 Unplug the iron and set the steam control to t (dry ironing). ¯2) 2 Wind the mains cord round the cord storage facility and store the iron on its heelâ¯(Fig. Troubleshooting This chapter summarises the most common problems you could encounter with the appliance. ¯If you are unable to solve the problem with the information below, visit www. Problem Water drips from the soleplate or wet spots appear on the garment during ironing. Solution Set an ironing temperature that is suitable for steam ironing. 1 Consult table 1 to set the temperature dial to the appropriate setting for your garmentâ¯(Fig. The temperature light goes on to indicate that the iron is heating upâ¯(Fig. 3 When the temperature lightâ¯goes out, the iron has reached the correct temperature. 4 Consult table 1 to select a steam setting that corresponds to the temperature you have setâ¯(Fig. Note:To use turbo steam , keep the steam control pressed to the turbo steam position continuously. Caution: Do not set the steam control to a steam setting if the set temperature is below 2 or when the iron is still heating up (when the temperature light is on). [. . . ] Set an ironing temperature at which the steam boost function can be used ( 2 to MAX). use the Calc-Clean function (see chapter âCleaning and maintenanceâ , section âCalc-Clean functionâ). [. . . ]