[. . . ] Aspire E1-572 / E1-570 / E1-532 / E1-530
User’s Manual
© 2013 All Rights Reserved. Aspire E1-572 / E1-570 / E1-532 / E1-530 User’s Manual This revision: 06/2013
AcerCloud frees you to enjoy your digital life anytime, anywhere!AcerCloud is a personal cloud service that allows you to access your files over the Internet and make sure your most important files are always up to date. With your personal cloud, all your connected devices (PC, tablet, phone) can access files on your main Cloud PC. [. . . ] See "Restore Factory Settings with Acer Recovery Management" on page 49. Customized Restore will attempt to retain your files (user data) but will reinstall all software and drivers. Software installed since you purchased your PC will be removed (except software installed from the Windows Store). See "Customized Restore with Acer Recovery Management" on page 51.
48 - Recovery
Restore Factory Settings with Acer Recovery Management 1. Click Restore Factory Settings.
Caution: 'Restore Factory Settings' will erase all files on your hard drive. Just remove my files quickly erases all files before restoring your computer and takes about 30 minutes. Fully clean the drive completely cleans the drive after each file is erased, so no files can be viewed after the recovery. Cleaning the drive takes much longer, up to 5 hours, but is much more secure as old files are completely removed. The recovery process begins by restarting your computer, then continues by copying files to your hard drive. After the recovery has finished, you can start using your computer by repeating the first-start process. Turn on your computer and press <Alt> + <F10> during startup. Note: "Refresh your PC" enables you to restore your computer to the default factory condition with files intact. "Reset your PC" completely removes all your files and resets your computer to factory settings. The process will take several minutes.
50 - Recovery
Customized Restore with Acer Recovery Management 1. The recovery process begins by restarting your computer, then continues by copying files to your hard drive. This process takes about 30 minutes.
Recovery - 51
Recovering from a recovery backup
To recover from a recovery backup on a USB drive: 1. If your computer does not have a built-in keyboard, make sure a keyboard is attached to your computer. Press the down key until F12 Boot Menu is selected, press <F5> to change this setting to Enabled. Depending on the type of BIOS your computer uses, select Save Changes and Exit or Exit Saving Changes and press Enter. The boot menu allows you to select which device to start from, select the USB drive. Windows starts from the recovery backup instead of the normal startup process. Click Advanced then System Restore to start Microsoft System Restore: Microsoft System Restore periodically takes a 'snapshot' of your system settings and saves them as restore points. [. . . ] The maximum allowed antenna gain for use with this device is 6 dBi in order to comply with the E. I. R. P limit for the 5. 25- to 5. 35 and 5. 725 to 5. 85 GHz frequency range in pointto-point operation.
Regulations and safety notices - 99
The FCC RF safety requirement The radiated output power of the wireless LAN Mini PCI Card and Bluetooth card is far below the FCC radio frequency exposure limits. Nevertheless, the computer shall be used in such a manner that the potential for human contact during normal operation is minimized as follows: 1. Users are requested to follow the RF safety instructions on wireless option devices that are included in the user's manual of each RF option device. Caution: To comply with FCC RF exposure compliance requirements, a separation distance of at least 20 cm (8 inches) must be maintained between the antenna for the integrated wireless LAN Mini PCI Card built in to the screen section and all persons. [. . . ]