[. . . ] Always here to help you Register your product and get support at www. Com/welcome RQ1100 series User manual 1 RQ119x, RQ118x, RQ117x, RQ116x, RQ115x, RQ114x, RQ113x ENGLISH 4 DANSK 27 SUOMI 50 FRANÇAIS 72 NEDERLANDS 95 DEUTSCH 118 ΕΛΛΗΝΙΚΑ 141 ITALIANO 166 NORSK 189 ESPAÑOL 212 PORTUGUÊS 235 SVENSKA 258 TÜRKÇE 280 4 ENGLISH Introduction Congratulations on your purchase and welcome to Philips!To fully benefit from the support that Philips offers, register your product at www. Please read this user manual, as it contains information about the features of this shaver as well as some tips to make shaving easier and more enjoyable. [. . . ] Note:You can also clean the shaving unit with the cleaning brush supplied. € 3 Pull the shaving head holder off the bottom part of the shaving unit and rinse it under a hot tap for 30 seconds. Note:You can also clean the shaving head holder with the cleaning brush supplied. € 4 Carefully shake off excess water and let the shaving head holder dry. Never dry the shaving unit with a towel or tissue, as this may damage the shaving heads. 16 ENGLISH 5 Reattach the shaving head holder to the bottom part of the shaving unit (‘click’). Cleaning the shaving unit in the Jet Clean System (RQ1197CC, RQ1195CC, RQ1185CC, RQ1180CC, RQ1175CC only) The Jet Clean System has an automatic cleaning program. When you press the on/off button, the Jet Clean System starts cleaning in this automatic cleaning program. Preparing the Jet Clean System for use Fill the cleaning chamber before first use. 3 Simultaneously press the release buttons on both sides of the cleaning chamber (1). € 5 Fill the cleaning chamber with HQ200 cleaning fluid to a level between the two lines. Using the Jet Clean System Note: If you use the shaver with shaving foam or shaving gel, we advise you to rinse it under the hot tap before you clean it in the Jet Clean System. ENGLISH 17 1 Hold the shaver upside down above the holder with the back of the shaver pointing towards the holder. 2 Place the shaver body in the holder behind the two clips (1) and press it down until it locks into place (2). , , The display shows that the shaver is charging (see chapter ‘The display’). 3 Press the on/off button on the Jet Clean System to start the cleaning program. , , The cleaning light starts to flash and the shaver is automatically lowered into the cleaning fluid. , , The cleaning light flashes throughout the cleaning program, which takes a few minutes. , , During the first phase of the cleaning program, the shaver automatically switches on and off several times and moves up and down. , , During the second phase of the cleaning program, the shaver is placed in the drying position, indicated by the flashing drying symbol. , , After the cleaning program, the charging indication appears on the shaver display (see chapter ‘The display’). Note: If you press the on/off button of the Jet Clean System during the cleaning program,  the program aborts. [. . . ] 26 ENGLISH Possible cause Solution Make sure you press the shaver until it locks into place. Problem You have not placed the shaver in the The shaver is not fully charged after I charge it charger/Jet Clean System properly. For at få fuldt udbytte af den support, Philips tilbyder, skal du registrere dit produkt på www. -- Shaveren og Jet Clean-systemet bør holdes uden for børns rækkevidde for at sikre, at de ikke kan komme til at lege med apparaterne. [. . . ]