[. . . ] Always here to help you
Register your product and get support at www. Com/welcome
RQ1200 series
User manual
1
ENGLISH 4 DEUTSCH 28 ΕΛΛΗΝΙΚΑ 52 SUOMI 77 FRANÇAIS 101 DANSK 126 NEDERLANDS 150 ESPAÑOL 175 ITALIANO 199 NORSK 223 PORTUGUÊS 247 SVENSKA 272 TÜRKÇE 296
RQ1200 series
4
ENGLISH
Introduction Congratulations on your purchase and welcome to Philips!To fully benefit from the support that Philips offers, register your product at www. Please read this user manual, as it contains information about the features of this shaver as well as some tips to make shaving easier and more enjoyable. [. . . ] -- Clean the shaver after every shave for optimal shaving performance. Always check if the water is not too hot, to prevent your hands from getting burnt. 3 Rinse all three shaving heads and all three hair chambers under a hot tap for 30 seconds. Note:You can also brush the shaving heads and hair chambers with the cleaning brush supplied. Always check if the water is not too hot, to prevent your hands from getting burnt. 4 Carefully shake off excess water and leave the shaving heads open to let the shaving unit dry completely. Never dry the shaving unit with a towel or tissue, as this may damage the shaving heads. Cleaning the shaving unit in the Jet Clean System (RQ1296CC, RQ1295CC, RQ1290CC, RQ1286CC, RQ1285CC, RQ1284CC, RQ1280CC, RQ1275CC, RQ1265CC, RQ1260CC, RQ1252CC, RQ1251CC, RQ1250CC only) The Jet Clean System comes in two types: -- Type RQ1008 has three cleaning programs: the eco program, the auto program and the intensive program. Press the up/down button to select the cleaning program you prefer. When you press the on/off button, the Jet Clean System starts cleaning in the automatic cleaning program. Preparing the Jet Clean System for use Fill the cleaning chamber before first use. ENGLISH
17
3 Simultaneously press the release buttons on both sides of the cleaning chamber (1).
5 Fill the cleaning chamber with HQ200 cleaning fluid to a level between the two lines. Using the Jet Clean System Note: If you use the shaver with shaving foam or shaving gel, we advise you to rinse it under the hot tap before you clean it in the Jet Clean System. 1 Hold the shaver upside down above the holder with the back of the shaver pointing towards the holder. 2 Place the shaver body in the holder behind the two clips (1) and press it down until it locks into place (2). , , The display shows that the shaver is charging (see chapter ‘The display’). 18 18
ENGLISH
4 Press the on/off button on the Jet Clean System to start the cleaning program. , , The cleaning light starts to flash and the shaver is automatically lowered into the cleaning fluid. , , The cleaning light flashes throughout the cleaning program, which takes a few minutes. , , During the first phase of the cleaning program, the shaver automatically switches on and off several times and moves up and down. , , During the second phase of the cleaning program, the shaver is placed in the drying position, indicated by the flashing drying symbol. [. . . ] In this case, the shaver does not work and the exclamation mark on the display flashes. 26 26
ENGLISH
Possible cause Solution Empty and rinse the cleaning chamber and refill it with new cleaning fluid. problem
The cleaning fluid in the cleaning chamber RQ1296CC , is soiled. RQ1295CC, RQ1290CC, RQ1286CC, RQ1285CC, RQ1284CC, RQ1280CC, RQ1275CC, RQ1265CC, RQ1260CC, RQ1252CC, RQ1251CC, RQ1250CC only: The shaver is not entirely clean after I clean it in the Jet Clean System. [. . . ]