[. . . ] Always here to help you
Register your product and get support at www. Com/welcome
SCF870
User manual
1
ENGLISH 6 ČEŠTINA 18 FRANÇAIS 30 HRVATSKI 43 MAGYAR 55 POLSKI 67 РУССКИЙ 81 SLOVENŠČINA 95 TÜRKÇE 107 УКРАЇНСЬКА 119
141
SCF870
6
ENGLISH
Introduction
Congratulations on your purchase and welcome to Philips AVENT!To fully benefit from the support that Philips AVENT offers, register your product at www. This combined steamer and blender is particularly suitable for preparing small amounts of baby food. [. . . ] , , The steaming time depends on the amount of water you have put in the water tank. See the table in chapter ‘Ingredients and steaming times’ and the recipe booklet. , , When the steaming process is finished, the appliance produces a buzzing sound and the steaming light goes out. Wait 2 minutes until no more steam comes out of the steam outlet, to avoid scalding by hot steam. 13) Note: If you want to steam another batch of ingredients, let the appliance cool down for 10 minutes before you start steaming again. 10 If you want to proceed with blending the steamed food, follow the instructions in section ‘Blending after steaming’ below. 10
ENGLISH
11 Under normal conditions, no water remains in the water tank after steaming. In case of scale build-up inside the water tank, interruption of the steaming process or unintended use), some water could remain in the water tank. In this case, empty the water tank completely after use to avoid bacterial growth. To descale the water tank, see chapter ‘Cleaning and maintenance’. Blending after steaming 1 Grab the jar handle and lift the jar off the motor unit. Turn the jar around and shake it so that the food falls down onto the blade unit (Fig. 2 If necessary, remove the lid and add additional ingredients for blending (e. Always make sure that the lid has cooled down after steaming before you open it to add more ingredients (do not exceed the maximum level indication) or to remove the remaining water from the water tank. After you have put liquids in the jar, never put the jar in the steaming position. Tip: Do not process a large quantity of solid ingredients at the same time. 5 Put the sieve in the lid of the jar (‘click’) (Fig. The small projections on the lid have to slide into the grooves in the jar. Make sure that the large projection of the lid is placed exactly over the handle of the jar. Make sure the handle is on the right-hand side and positioned between the two ridges of the locking area (Fig. Hold the knob in this position for as long as you need but for not more than 30 seconds (Fig. Note: If the ingredients stick to the wall of the jar, switch off the appliance and loosen them with the spatula or add some liquid. [. . . ] The steaming light goes on again after the steaming process is finished. The motor unit gives off an unpleasant smell during the first few times of use. You have accidentally left the jar on the base for more than 10 minutes without switching off the appliance. If the appliance continues to give off this smell after you have used it a few times, check whether the processing quantity and processing time are correct. [. . . ]