[. . . ] € Remove the battery if you do not use the unit for a long period of time or if the unit is to be powered exclusively by AC power. This product incorporates the following software: (1) The software developed independently by or for Panasonic Corporation, (2) The software owned by third party and licensed to Panasonic Corporation, and/or (3) Open source software The software categorized as (3) is distributed in the hope that it will be useful, but WITHOUT ANY WARRANTY, without even the implied warranty of MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. Permission is hereby granted, free of charge, to any person obtaining a copy of this software and associated documentation files (the “Software”), to deal in the Software without restriction, including without limitation the rights to use, copy, modify, merge, publish, distribute, sublicense, and/or sell copies of the Software, and to permit persons to whom the Software is furnished to do so, subject to the following conditions: The above copyright notice and this permission notice shall be included in all copies or substantial portions of the Software. Book Page 3 Friday, January 3, 2014 4:54 PM Overview of controls Front view 1 2 3 4 Rear view L M N O P K J 9 8 7 6 5 L Antenna Extend the antenna, adjust the length, angle and direction for best reception. [. . . ] – Listening to a preset station Press the direct preset button ([1] to [10]) to listen to the preset station. manual tuning You can perform manual tuning to a particular channel or frequency. This can be useful when you are adjusting the antenna to achieve the best possible reception and scanning a particular channel to update the station list. Viewing available information You can view the information of the radio station such as RDS text (available in some areas), frequency and date. Turn [ TUNE/SELECT ] to select “Manual tune” and then press [ENTER]. Turn [ TUNE/SELECT ] to select a frequency or channel and then press [ENTER]. The display shows the received signal strength of the selected frequency. Threshold indicator Adjust the antenna so that the received signal strength (solid rectangles) exceeds the threshold indicator. Viewing available information RQTN0173 You can view various information about the DAB broadcast such as dynamic label information (if available), signal strength, program type, ensemble name, channel number, bit rate, DAB variant and date. Book Page 6 Friday, January 3, 2014 4:54 PM System settings █ To view the System menu When in DAB mode Time 1 2 Press [MENU]. ] to select “System” and Backlight The time and date information are updated automatically with the DAB/RDS broadcast (if available). English, Italiano, Deutsch, Français Yes, No Select “Yes” to reset the unit to factory default setting. If FM or DAB is set, select the last station you tuned in to (“Last listened”) or a preset station as the audio source. € Set the volume The alarm starts at a low volume and increases gradually to the preset level. Note: • The alarm does not work when the unit is powered by batteries. € Check that the date and time are set correctly, or else the alarm may not work as desired. € The alarm will come on at the set time every day for a duration of 90 minutes. € You need to set the alarm again every time you disconnect and connect the AC power or after you remove the batteries. Move mobile telephones away from the unit if the interference is apparent. €Time Not saved” • The changes made to the time was not saved, the changes will be lost. €Alarm Not saved” • The changes made to the alarm was not saved, the changes will be lost. Sleep The sleep timer switches off the unit after the set time (in minutes). [. . . ] Permission is hereby granted, free of charge, to any person obtaining a copy of this software and associated documentation files (the “Software”), to deal in the Software without restriction, including without limitation the rights to use, copy, modify, merge, publish, distribute, sublicense, and/or sell copies of the Software, and to permit persons to whom the Software is furnished to do so, subject to the following conditions: The above copyright notice and this permission notice shall be included in all copies or substantial portions of the Software. Book Page 3 Friday, January 3, 2014 4:54 PM Oversikt over betjeningselementer Front 1 2 3 4 Bakside L M N NORSK RQTN0173 O P K J 9 8 7 6 5 L Antenne Trekk ut antennen, juster lengden, vinkelen og retningen for best mulig mottak. Trykk [MENU] for å velge "Full scan" (Full skanning) og trykk deretter [ENTER] for å starte full skanning. ] for å velge en stasjon fra Visning av tilgjengelig informasjon Du kan se forskjellig informasjon om DAB-kringkasting, som for eksempel dynamisk merkeinformasjon (hvis tilgjengelig), signalstyrke, programtype, artistnavn, kanalnummer, bit-hastighet, DAB-variant og dato. [. . . ]