[. . . ] Der Fettfilter nimmt die fettigen Bestandteile des Küchendunstes auf. Wird kein Aktivkohlefilter eingebaut, können keine Geruchsstoffe des Küchendunstes gebunden werden.
3
Before using for the first time
Important notes:
The Instructions for Use apply to several versions of this appliance. Accordingly, you may find descriptions of individual features that do not apply to your specific appliance. The appliance may be connected to the mains by a qualified technician only. [. . . ] Intensive setting: Maximum power is obtained at the intensive setting. If the intensive setting is not cancelled by hand, the fan will automatically switch back to step } after 10 minutes.
Filters and maintenance
Removing and inserting the metal grease filters: Warning: The halogen bulbs must be switched off and cool. Press the catch on the grease filters inwards and fold the filters down. Insert the metal grease filters (see "Removing and inserting the metal grease filters"). Removing the filter: Warning: The halogen bulbs must be switched off and cool. Press in the lug at the front and remove the activated carbon filter.
2. Insert the clean filters back into the hood.
Activated carbon filter:
For neutralizing odours in recirculating mode. Remove the metal filters (see "Removing and inserting the metal grease filters"). Replacing the activated carbon filter: During normal operation (1 to 2 hours per day) the activated carbon filters should be replaced approximately 1 x year. A replacement filter can be obtained from any authorized dealer (see optional accessories). By doing so you will obtain maximum performance from your extractor hood. flying sparks) unless the cooker features a closed, non-removable cover and all national regulations are observed. The smaller the gap between the extractor hood and hotplates, the greater the likelihood that droplets will form on the underside of the extractor hood. Additional information concerning gas cookers: When installing gas hotplates, comply with the relevant national statutory regulations (e. g. Always comply with the currently valid regulations and installation instructions supplied by the gas appliance manufacturer. Only one side of the extractor hood may be installed next to a high-sided unit or high wall. Minimum distance on gas hotplates between the upper edge of the trivet and lower edge of the extractor hood: 650 mm, Fig. 1.
8
Prior to installation
Exhaust-air mode
mind. 38 550
120 150 120 150
715-1100 630
mind
. 128
260
280
mind. 600
48
520
00 0/9 /70 600
The exhaust air is discharged upwards through a ventilation shaft or directly through the outside wall into the open. D Exhaust air should neither be directed into a smoke or exhaust flue that is currently used for other purposes, nor into a shaft that is used for ventilating rooms in which stoves or fireplaces are also located. Exhaust air may be discharged in accordance with official and statutory regulations only (e. g. Local authority regulations must be observed when discharging air into smoke or exhaust flues that are not otherwise in use. [. . . ] Drill 4 x l 8 mm holes for the extractor hood and 2 x l 8 mm holes for the chimney panelling. Insert plugs into the holes so that they are flush with the wall.
23
Note: Take into account any special accessories that are going to be fitted. Attach the 2 enclosed spacers to the fixing bracket for the flue duct panelling. Adjust the height and align horizontally with the adjusting screws.
172
455 68
150
mind. 550 Elektro mind. 650 Gas
The glass screen must not touch the wall. [. . . ]