[. . . ] To reduce the risk of electric shock, do not disassemble this appliance, but take it to qualified service personnel when service or repair work is required. Incorrect reassembly can cause electric shock when the appliance is used subsequently. The use of an accessory attachment not recommended by the manufacturer may cause a risk of fire, electric shock, or injury to persons. When disposing of the batteries, please contact your local authorities or dealer and ask for the correct method of disposal. [. . . ] shooting
1 [AUTO CHECK] lamp
1 [ON/OFF] button 2 [CHARGE] lamp 3 [AUTO CHECK] lamp
Press the [ON/OFF] button. Replace the batteries if the [CHARGE] lamp does not light after: 30 seconds (Alkaline dry batteries) 10 seconds (Rechargeable nickel metal hydride batteries) ≥ If the [CHARGE] lamp and [AUTO CHECK] lamp blink simultaneously, batteries are running low. The flash will enter sleep mode whenever the camera enters sleep mode. If no operations are performed for approximately 20 minutes, the flash will turn off automatically. Oscillating sound may be output while charging the flash, but this is not malfunction. Flash Mode” (P9) See the camera operating instructions for details. 4 Press the shutter button the rest of the way down to take the picture. The unit emits light in proper exposure if [AUTO CHECK] lamp flashes for approximately 5 seconds. When using a flash, flash light may be blocked by the lens body, lens hood, etc. Use the wide panel to prevent overexposure at ranges of less than 1 m (3. Fm
9 ページ
２０１６年４月２２日 金曜日 午後６時０分
∫ Firing a test flash
Press the [TEST] button while the [CHARGE] lamp is lit to fire a test flash. 1 [CHARGE] lamp 2 [TEST] button
[MANUAL] The flash is fired at the intensity that you set. Select this mode when using a camera without communication capability. Rotate the flash exposure compensation/output control dial to set the flash output. [SLAVE] (SL MANUAL) The flash can be fired remotely in sync with any flash fired by other units. Rotate the flash exposure compensation/output control dial to set the flash output. [RC] Wireless control is available with Panasonic digital cameras that support wireless mode. (P10)
Flash Mode
Choose a flash mode according to your subject and shooting conditions. [TTL] (TTL AUTO) The flash light intensity is controlled automatically according to the camera’s setup. The flash will be adjusted based on the brightness taken through the camera’s lens. Rotate the flash exposure compensation/output control dial to adjust the flash output. You can make an adjustment by selecting a value between j3 EV and i3 EV. [. . . ] Digital Camera Digital Camera Peripherals Digital Camera Accessories One (1) year, parts and labour One (1) year, parts and labour Ninety (90) days, parts and labour This warranty is given only to the original purchaser, or the person for whom it was purchased as a gift, of a Panasonic brand product mentioned above sold by an authorized Panasonic dealer in Canada and purchased and used in Canada, which product was not sold “as is”, and which product was delivered to you in new condition in the original packaging. The warranty ALSO DOES NOT COVER damages which occurred in shipment, or failures which are caused by products not supplied by Panasonic Canada Inc. , or failures which result from accidents, misuse, abuse, neglect, mishandling, misapplication, alteration, faulty installation, set-up adjustments, misadjustment of consumer controls, improper maintenance, improper batteries, power line surge, lightning damage, modification, introduction of sand, humidity or liquids, commercial use such as hotel, office, restaurant, or other business or rental use of the product, or service by anyone other than a Authorized Servicer, or damage that is attributable to acts of God. Dry cell batteries, printer ink cartridge and paper are also excluded from coverage under this warranty. [. . . ]