[. . . ] Each day the discovery of a truly emotive experience from an unencountered sound awaits. (2) English Delivering the Ultimate Emotive Musical Experience to All At Technics we understand that the listening experience is not purely about technology but the magical and emotional relationship between people and music. We want people to experience music as it was originally intended and enable them to feel the emotional impact that enthuses and delights them. Through delivering this experience we want to support the development and enjoyment of the world’s many musical cultures. [. . . ] 15 English (15) Adjustment Horizontal balance Preparation  First , remove the dust cover. ρ Remove the stylus cover, taking care not to damage the stylus, then release the arm clamp. ρ Return the tone arm to the arm rest and fix it with the arm clamp. 1 Free the tone arm from the arm rest and adjust horizontal balance by turning the balance weight. Hold the tone arm and turn the balance weight in the arrow direction to adjust the balance until the arm is approximately horizontal. ρ Take care not to Balance weight allow the stylus tip to touch the Hold here turntable or main to turn unit. 1 Turn the stylus pressure control until “0“ comes to the centre line of the rear of the tone arm. Stylus pressure control Hold here to turn Balance weight Centre line Arm clamp Arm clamp Arm rest Cue lever Anti-skating control Note  Refer to the user's guide for your stylus for the appropriate stylus pressure. 16 (16) English Anti-skating 2 Turn the balance weight to adjust to the appropriate stylus pressure for the cartridge. ρ The stylus pressure control will turn together with the balance weight. ρ Turn until the centre line points to the appropriate stylus pressure. 1 Turn the anti-skating control to adjust it to the same value as the stylus pressure control. Getting started Balance weight Hold here to turn Turns together 1 0 Centre line Note  For stylus pressures 3 g and above, adjust anti-skating control to “3”. 2 3 17 English (17) Adjustment (continued) Tone arm height Make this adjustment only if the cartridge you are using makes it necessary. 3 After arm height adjustment is finished, lock the tone arm by turning the arm lock knob. When you don't know the cartridge  height (H), Remove the stylus cover, taking care not to damage the stylus, then release the arm clamp. Lower the cue lever, rest the stylus on the record and adjust the height control until the tone arm and record are parallel. Parallel to the turntable Arm lock (Released) (Locked) 2 Adjust the height with the armheight control ring. Adjust the arm height until the tone arm becomes parallel to the record. ρ Use the chart below as reference to find the appropriate position mark for the height of your cartridge. (For supplied head shell) Cartridge height (H) in millimeters 17 18 19 20 21 22 23 Height control position 0 1 2 3 4 5 6 Attention  Be careful not to damage the stylus tip. ρ Turn the arm-height control ring to align the position mark with the index line. [. . . ] ρ If after connecting the USB memory and turning [ON/OFF] to ON, the update lamps fail to light up within 15 seconds or they are blinking, see the following website. Com/support/firmware/ The Strobe light or the blue indicator blinks. Perform the following operation when the strobe light or the blue indicator blinks. ρ Pull out the power plug, wait for three seconds, and then insert the plug again. [. . . ]