[. . . ] Book Page 2 Wednesday, October 1, 2008 10:51 AM
NOTICE FOR CUSTOMERS IN THE UNITED KINGDOM
A moulded plug complying with BS1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, a 10 AMP fuse approved by ASTA or BSI to BS 1362 (i. When an alternative type of plug is used it should be fitted with a 10 AMP FUSE otherwise the circuit should be protected by a 10 AMP FUSE at the distribution board. If the plug supplied with this equipment has a detachable fuse cover, be sure to attach the fuse cover after you change the fuse. [. . . ] Press the HOME button on your remote control to access the XMB™. You can also select a channel using the number buttons or PROG +/–. You can also select a channel using the number buttons or PROG +/–. to hide the list of analogue channels , set “Programme List Display” to “Off” (page 28). to assign a label to an external input , see “AV Preset” (page 27). Analogue
External Inputs
3 Press F/f to select the item, then press 4 Follow the instructions on the screen. Book Page 22 Wednesday, October 1, 2008 10:51 AM
Settings
Instruction Manual (Only for KDL-52W4xxx, KDL-46W4xxx, KDL-40W4xxx, KDL-32W4xxx, KDL-40E4xxx, KDL-32E4xxx)
Displays contents of Instruction Manual on the screen. press F/f/G/g to select , then press to go to related item or access real application. Picture Picture Mode
Selects the picture mode except for PC input source. The options for “Picture Mode” may differ depending on the “Video/Photo” setting (page 25). This picture setting was developed in collaboration with Sony Pictures Entertainment to faithfully reproduce movies as intended by their creators. Display Mode (only in
PC mode/ PC Input/ HDMI PC Input)
Reset Backlight Contrast Brightness Colour Hue
Resets all picture settings except “Picture Mode” and “Display Mode” (only in PC mode) to the factory settings. Z
“Hue” can only be adjusted for an NTSC colour signal (e. Book Page 23 Wednesday, October 1, 2008 10:51 AM
Colour Temperature
Adjusts the whiteness of the picture. Warm 2” gives a redder tint than “Warm 1”
z
“Warm 1 and Warm 2” are not available when “Picture Mode” is set to “Vivid”. Auto”: Automatically reduces the picture noise (in analogue mode only). “Off”: Turns off the “Noise Reduction” feature. Z
“Auto” is not available for AV1, AV2, AV3, HDMI 1, HDMI 2, HDMI 3, Component, PC and digital mode. MPEG Noise Reduction Advanced Settings
Reduces the picture noise in MPEG-compressed video. When you set “Picture Mode” to “Cinema” or “Standard”, you can set/change these settings. Contrast Enhancer”: Automatically adjusts “Backlight” and “Contrast” to the most suitable settings judging from the brightness of the screen. It will increase the contrast distinction of the darker picture scenes. [. . . ] 2 If the problem still persists, have your TV serviced by qualified service personnel. Picture
No picture (screen is dark) and no sound • Check the aerial/cable connection. Connect the TV to the mains, and press 1 on the top edge of the TV. No picture or no menu information from equipment connected to the scart connector • Press / to display the connected equipment list, then select the desired input. [. . . ]