[. . . ] No claims may be made for wear and tear or if the colours fade when exposed to strong sunlight. The fabric covers on this product can be washed by hand or on a cold cycle in the washing machine (mild detergent). An ABC Design rain canopy is available in retail stores offering complete protection against the rain. All the frames on our products have been tested for conformity with EN1888 : 2012 and have met the required standards. [. . . ] Carry Cot: This product is suitable for infants who cannot sit up or turn over independently and who cannot get up on their hands and knees. Maximum weight of child: 9kg
CAUTION: • Do not leave your child unattended. Loads attached to the handle affect the stability of the pushchair. Before use, check that the pushchair attachment or seat is correctly engaged in position. Do not make any modifications to the product which compromise its safety. To avoid injury ensure that your child is kept away when unfolding and folding this product. Check that the pram body or seat unit or car seat attachment devices are correctly engaged before use. EN - 04
Customer complaints
• No claims may be made for natural wear and tear or for damage caused by undue demands on the product or by exceeding the permissible load. No claims may be made for damage caused by incorrect assembly or operation. No claims may be made for damage caused by improper modifications to the product. Areas of rust may appear through lack of maintenance or improper care and do not constitute a fault with the product. Scratch marks are normal signs of wear and do not constitute a fault with the product. Mildew is likely to appear on textiles which are not dried out after getting wet and cannot be attributed to shortcomings in production conditions. The product may fade if exposed to sunlight, perspiration and detergents, or if subject to abrasion or excessive washing, therefore fading cannot be attributed to a fault with the product. No claims may be made for wheels which become worn out as a natural result of wear and tear. To remove the wheels, press the button on the rear axle down to release the wheel. Mount the front wheels by sliding the wheel assemblies onto the prongs until they click into place. To remove the wheel assemblies, press the button underneath the blocks and remove the assemblies. Wheel locking and swivel settings Push the lever downwards to lock the wheels. NB: The brake must always be applied before lifting the children in and out of the buggy. [. . . ] Adjusting the handle Push the button upwards to adjust the height of the handle. When the handle is at the required height, let go of the button again so that the handle will remain locked in this position. Folding the pushchair NB: Remove the seat unit or carrycot before attempting to fold the pushchair. Pull the two release catches on the left and right sides of the handlebar up. [. . . ]