[. . . ] Before handling any components, be sure to wear an anti-static wrist strap (not included) and touch a grounded metal object to release any built-up static electricity.
1
English
Getting Started
Installation
WARNING!Do not connect any power cable to live AC outlets until configuration and setup is complete.
English
2
1
Install memory modules
Memory module
1. [. . . ] Position the I/O side of the motherboard towards the chassis rear panel, matching the I/O ports to the openings of the I/O shield. Make sure that the underside of the motherboard is not touching the chassis, otherwise, a short circuit may occur.
Mounting screws
Standoffs
Motherboard screw holes
4
4
Install hard disk and floppy drives
1. If installing two IDE hard disk drives on the same cable, set one device as "Master" and the other as "Slave. " Check the label on the IDE device for the jumper settings. If installing IDE hard disk drives, connect the IDE signal cable and power cable. If installing SATA hard disk drives, connect the SATA signal cable and power cable.
IDE
Power cable
IDE signal cable
Serial ATA Floppy disk
Power cable
Floppy disk signal cable
Power cable
SATA signal cable
5
English
English
6
5
Connect drive signal cables
1. Make sure the side of the cable with the colored stripe is plugged into pin 1 of the floppy disk connector. Make sure the side of the cable with the colored stripe is plugged into pin 1 of the IDE connector. If you're using SATA hard disk drives, connect the SATA signal cable. Floppy disk
IDE
Serial ATA
6
Connect the chassis LED and power switch cable
On the front of your chassis, you will find some LED and power switch leads. Connect these leads to the panel connector on the motherboard.
LED and switch leads
7
Install expansion cards
1. Remove the slot covers from the chassis where you wish to install the expansion cards. PCI card AGP card Wi-Fi card
7
English
English
8
8
Connect the power supply cables
The plugs from an ATX power supply are designed to fit the power connectors on the motherboard. [. . . ] · Check the floppy drive cable, make sure it is connected properly. · Check the IDE drive cables, make sure they are corrected properly. [. . . ]