[. . . ] Movita junior User manual These operating instructions contain information, settings, safety precautions, which are to be considered with the use of Movita junior, as well as other important data. Movita junior are walking aids for children starting with age 7 and for adult body size from approx. [. . . ] Assembling upper section and underframe Upper section needs to be put on top of the underframe. Basic model adjustment Height of the thoracic support and seat For height adjustment of the thoracic support, loosen the two bottom handles (fig. Once the desired height has been reached, the handles need to be tightened whereby the same height can be adjusted on both sides with the help of the height framework. Once the desired height has been achieved both handles need to be tightened, whereby with the help of the height framework the exact height can be adjusted. Thoracic support The thoracic support can be opened or closed through lightly raising or down-pressing the padded pipe (fig. Springs The two springs in the lower pipes can be exchanged, if a harder or softer suspension is needed (fig. The springs are available in four different levels of stiffness, which are appropriate for the following body weights 20 kg - 40 kg -60 kg -80 kg. If the desired position is found the screw needs again to be tightened. In addition also the angle of the seat can be adjusted again by loosening the two internal hexagonal screws under the seat (fig. After adjusting, the screws are tightened again. Manufacturer: elmi GmbH - Handwerkerzone 25 - I-39052 Kaltern - Tel 0471 961002 - FAX 0471 962374 elmisrl@tin. it www. movita. it -2- Movita junior User manual Pelvic support The pelvic support behind the seat can be lifted or pushed down; whereby an internal hexagonal screw becomes visible. [. . . ] CE- tested brand: Movita junior is provided with a CE-marking. Technical data length Movita junior 86 cm width seat height thoracic support height (side) thoracic support, perimeter wheels dimension front wheels dimension rear load in relation to shock absorbers frame wheels thoracic support and handle seat 69 cm 46-67 cm 76-97 cm 70/90/105/ 140x30 mm 400 x 40 mm 20 kg / 40 kg / 60 kg / 80 kg stainless steel tubular frame, powder coated full rubber, suitable for indoor and outdoor use covered with soft and anallergic rubber anatomic Abb. 11 Manufacturer: elmi GmbH - Handwerkerzone 25 - I-39052 Kaltern - Tel 0471 961002 - FAX 0471 962374 elmisrl@tin. it www. movita. it [. . . ]