[. . . ] INSTALLATION INSTRUCTIONS FOR 55-0401x-121 SERIES 1187001PL 2001 DURANGO OVERHEAD CONSOLE for use with FLIPDOWN VIDEO SYSTEM These instructions are intended for use only by experienced professionals in the automotive customizing business. Special tools and equipment, as well as specialized handling and care of product during installation, may be required. Before beginning this installation, carefully read through the following instructions. [. . . ] It may be necessary to lower the driver's side of headliner at the "B" pillar to gain access to the 3rd clip. 4 Use caution when pulling on wire harness and pulling downward on headliner. The connector should reach the rear cut-out in headliner when all clips are released. FIGURE 4 5. Install and route all video and audio cables, and any other added component requirements to their respective places in the vehicle. The suggested routing of the video system cable is as follows: Above the headliner from video system to the C-pillar. Route the remaining wiring (RCA plugs, Remote Sensor extension, etc. ) to the VCP location. If video system if to be used as a television, install an appropriate antenna per instructions included with the antenna. FIGURE 5 6. Construct a 3' jumper harness that will connect the vehicle's dome light wires to the lights in video system. Remove and retain mounting bracket and screws (items 5&3 pg2) from console (item 6 pg2). Use rubbing alcohol to clean sheet metal in the cut­out area in headliner. Remove protective tape from adhesive strips on mounting bracket (item 5 pg2). Make sure bracket is centered prior to pressing tape against roof surface. Once the tape is applied to the roof, DO NOT REMOVE AND REPOSITION or the tape will not stick properly. screws in original holes and (2) two # 10 x 1/2" TEK screws (item 2 pg2). [. . . ] For further assistance, refer to the video system manual for the technical support phone number listed for your area. FIGURE 10 17. Note: Make sure wires do not get pinched between video system and console. Secure using (4) four 6-32 x 3/4"screws and (4) four 3. 5 mm washers (items 3&4 pg2). [. . . ]