[. . . ] MODULE INSTRUCTIONS MKZ3 XKZ3 FOR QUANTUM BATTERY 1/1+ AND QUANTUM BATTERY 1 COMPACT FOR BANTAM BATTERY AND QUANTUM BATTERY 1 COMPACT U. S. [. . . ] If the flash does not power up * within one second, turn the Quantum Battery 1, 1+, 1C OFF immediately **. Plug the module into one of the flash outputs on the Bantam Battery or the Quantum Battery 1C. If the flash does not power up * within one second, remove the plug from the Bantam Battery or Quantum Battery 1C immediately **. See Notes ! FIGURE 1: For most flash models FIGURE 2: For Nikon SB27 NOTES: For Quantum Battery 1 Compact: This battery works with either MKZ3 or XKZ3. * You can tell the flash is powered-up by checking to see if the LCD Panel on the flash becomes active, or by listening for the whine of the flash recycling. ** If the flash does not respond, check to see if the module is correctly orientated inside the flash. If you still have difficulty, consult your dealer or contact us for assistance before proceeding. SECURING THE MODULE: 1. Using plastic screwdriver (attached to cord) turn screw in module counterclockwise 3 turns, or until wedges retract fully. Press module down firmly with finger and turn screw clockwise approximately 3 full turns. [. . . ] Garden City NY 11530 516 222 6000 (TEL) 516 222 0569 (FAX) quantrep@qtm. com www. qtm. com P592 [. . . ]