[. . . ] Quantum PX502 Chassis Unpacking Instructions
Introduction Removing the New Library Chassis from the Shipping Carton Removing the Remaining Packing Materials Preparing for Multiple Library Stacks
3 3 5 9
Document 81-81331-01 C01, June 2005
1
Quantum PX502 Chassis Unpacking Instructions Document 81-81331-01 C01 June 2005
2
Quantum PX502 Chassis Unpacking Instructions Document 81-81331-01 C01 June 2005
Introduction
This document explains how to unpack the Quantum PX502 library chassis. [. . . ] Caution: Take standard ESD precautions when performing this procedure.
2 Insert the metal pick included with the accessory kit into the release holes and trip the magazine door release for both the right and left magazine doors (see figure 2). The magazine access doors open.
Figure 2 Opening the Right and Left Magazine Access Doors
Left magazine door
Door releases
Right magazine door
Removing the Remaining Packing Materials
5
Quantum PX502 Chassis Unpacking Instructions Document 81-81331-01 C01 June 2005
3 Insert the wooden dowel that is included in the library accessory kit into the magazine release hole and trip the magazine release to remove the each magazine from the library (see figure 3). Note: Keep the tool as straight as possible when inserting the wooden dowel into the magazine release hole. You must continue to hold the tool against the magazine release until the magazine is entirely out of the library.
6
Removing the Remaining Packing Materials
Quantum PX502 Chassis Unpacking Instructions Document 81-81331-01 C01 June 2005
Figure 3 Removing the Magazines
Magazine release hole
Magazine release
Magazine release (engaged)
Right magazine
Removing the Remaining Packing Materials
7
Quantum PX502 Chassis Unpacking Instructions Document 81-81331-01 C01 June 2005
4 To remove the robotics restraints (see figure 4): a b c d Disconnect the two velcro straps securing the robotics restraints to the library chassis. Pull the straps away from the chassis anchors and remove the straps from the library. Lift the left robotics restraint slightly up and remove it from the library. Slide the right robotics restraint to the right until you are clear of the robotics motor and remove the restraint from the library. Avoid touching the printed circuit board and ribbon cable connectors on the robotic hand.
Caution:
Figure 4 Removing the Robotics Restraints
Velcro straps
Robotics restraints
Note:
Save the robotics restraints for later shipping or relocation of the library.
8
Removing the Remaining Packing Materials
Quantum PX502 Chassis Unpacking Instructions Document 81-81331-01 C01 June 2005
5 Remove the tape drive cover plates by loosening the captive screws securing the plate to the library chassis with a flat blade screwdriver (see figure 5).
Figure 5 Removing the Tape Drive Cover Plates
Captive screws
6 Replace the right and left magazines in the library. [. . . ] Install only the bottom alignment hardware on the top library in the stack and the top alignment hardware on the bottom library in the stack.
Note:
10
Preparing for Multiple Library Stacks
Quantum PX502 Chassis Unpacking Instructions Document 81-81331-01 C01 June 2005
Figure 7 Installing the Alignment Hardware
Screws Top alignment hardware
Bottom alignment hardware Screws
The libraries are prepared for installation in a multiple stack.
Preparing for Multiple Library Stacks
11
Quantum PX502 Chassis Unpacking Instructions Document 81-81331-01 C01 June 2005
12
Preparing for Multiple Library Stacks [. . . ]