[. . . ] Assembly Instructions for Model: VMUC1 Thank you for choosing a Sanus Systems Vision Mount under cabinet mount. The VMUC1 is designed to hold up to a 17 inch flat panel LCD weighing up to 18 lbs. [. . . ] Note: Make sure the spikes on the T - Nuts is facing toward the cabinet. Diagram 3 Detailed View b cabinet c spike Step 4: Attach flat panel display to mounting plate Make sure no power is supplied to the display before mounting the display!Once the Mount Assembly (a) is secured to the cabinet, align the appropriate slots in the mounting plate with the four mounting holes of your LCD display. Use either four M4 x 10 mm Bolts (d) or four M4 x 20 mm Bolts (e) with four . 5 inch Spacers (f). Diagram 4b on the next page shows the M4 x 20 mm Bolts with the . 5 inch Spacers. Detailed View Diagram 4a LCD panel d mounting plate Step 4 (cont) The . 5 inch Spacers (f) should only be used if there is an obstruction or the hole pattern is physically recessed on the back of the LCD panel. See Diagram 4b for assistance. Detailed View Diagram 4b e mounting plate f LCD Panel Step 5: Adjusting the screen height. Using a Phillips screw driver, slightly loosen the Bolts (d, e) that secure the LCD panel to the mounting plate. Tighten the Bolts (d, e) to secure the LCD panel to the mounting plate. Diagram 5 d, e mounting plate Step 6: Adjust tension of Mount Assembly The tension of the Mount Assembly (a) can be adjusted by simply tightening or loosening the tension bolt labeled in Diagram 6 with the provided Allen Key (h). [. . . ] Diagram 10 cable tie holder a cable path Sanus Systems 2221 Hwy 36 West, Saint Paul, MN 55113 1. 3. 05 Customer Service: 800. 359. 5520. See complementary Sanus products at www. sanus. com Dimensional Drawing - Scaled 1:1 Front 3. 28 1. 89 1. 89 Back [. . . ]