[. . . ] Upgrading the firmware for the Access Point: If you have already installed the Access Point software skip to Step 2 or 3 depending on your configuration. Access your CD-ROM drive by double-clicking on the CD-ROM icon in the "My Computer" window. [. . . ] Step 4: Connect to the Wireless Access Point in order to upgrade the firmware. Start the WAP Manager Software by clicking "Start", "Programs", then select "Belkin Wireless Access Point Manager", then click on "Belkin Wireless Access Point Manager". Once you launch the WAP Manager Software, a window will open and begin scanning for your WAP. The words "Scanning AP" will be displayed in the bottom right corner of the window. When finished scanning, "Scanning complete" will be displayed. You can connect to the WAP from any computer on the network that is either wired or wireless. Your WAP is shipped from the factory with the name "MiniAP". If your WAP is installed properly, you should see the name "MiniAP" in the "Wireless Manager" window when scanning has completed. Connecting to the WAP To make any changes to the configuration of the WAP, you must connect to the WAP by entering a password. The WAP is password-protected to keep unauthorized users from changing settings. Click on "Command" and select "Connect AP. . . " in the drop-down menu. The "Input Password" window will appear. Your WAP ships from the factory with the password set to "MiniAP". [. . . ] A Window will pop up stating "Update firmware successfully". In order to make any final changes just follow the instructions to connect to the WAP. [. . . ]