[. . . ] Français 2 English 4 Español 6 Português 8 Please keep both flaps open when reading these operating instructions. Getting Started · Check the dust bag is in place · Insert the hose until the catches click to engage. [. . . ] Confined areas: Use the crevice nozzle for crevices, corners and radiators. Dust bag indicator and changing the dust bag For peak performance the dust bag must be changed when full. If the dust bag breaks in the cleaner, the 4x4 must be taken to an Authorised Service Centre for cleaning. The dust bag indicator window will gradually turn red when filling and completely red when full. To check the dust bag, the cleaner must be switched on, with all attachments connected and off the floor. The dust bag full indicator may signify that the bag is blocked (occasionally caused by very fine dust) which will cause loss of suction and may result in overheating. To change the dust bag: A Release catch and swing back lid before removing the dust bag, bend the tab into the hole to prevent dust escaping B Remove the dust bag C Insert new dust bag by fitting the bag slots over holders. We recommend the dust bag is changed: * after using a carpet cleaning powder * if there is a bad smell from the cleaner, when you should also change the filter. [. . . ] Water: If water is sucked into the cleaner the motor must be changed at an Authorised Service Centre. [. . . ]