User manual AEG-ELECTROLUX ECG6600

[. . . ] Customer g Dear read this user manual carefully, Please Paying special attention to the safety notes!Keep the manual in a safe place for later reference, and pass it on to any new owner. Key to picture Front view (Figure 1) Milk container (Figure 2) Front view with open service door (Figure 3) 1. 8 Looking up the number of coffees dispensed, number of jugs dispensed and number of descaling procedures (statistics) 130 13. [. . . ] Press the scrolling buttons "<" or ">" (Figure 6) until desired language appears. When the desired language is displayed, confirm it with the"OK" button (Figure 6). If "OK" is not pressed, the appliance automatically returns to the coffee mode after about 120 seconds without saving the entries. If coffee is dispensed too quickly or too slowly (in drips), you can change the grind level during the milling process. Changing the settings when the mill mechanism is at rest can damage the coffee machine. 0 Adjust the grind level with the knob for setting the grind level (Figure 2, T) (Figure 12). ⷠIf the coffee only comes out in drips or not at all, the knob must be turned by one position clockwise. ⷠIf the coffee comes out too fast and the crema does not meet your taste, turn the knob by one position anticlockwise. Make sure that you do not turn the knob for setting the grind level too far, as otherwise coffee may come out in drips when dispensing 2 cups. The display automatically jumps back to the menu option «CHOOSE LANGUAGE» after programming. 0 To go back to the coffee mode, press the "MENU" button (Figure 5)or wait about 120 seconds until the appliance automatically jumps back to coffee mode. The coffee temperature levels are defined as follows: «TEMPERATURE LOW» «TEMPERATURE MEDIUM» «TEMPERATURE HIGH» The factory setting is «TEMPERATURE HIGH». You can change this as follows: Press the "MENU" button (Figure 5). If necessary, select another temperature with the scrolling buttons "<" or ">" (Figure 6). When the desired temperature is displayed, confirm it with the"OK" button (Figure 6). You can change this as follows: Press the "MENU" button (Figure 5). If necessary, select another switch-off time with the scrolling buttons "<" or ">" (Figure 6). When the desired switch-off time is displayed, confirm it with the"OK" button (Figure 6). If "OK" is not pressed, the appliance automatically returns to the coffee mode after about 120 seconds without saving the entries. The display automatically jumps back to the menu option «AUTO SHUTOFF TIME» after programming. To go back to the coffee mode, press the "MENU" button (Figure 5) or wait about 120 seconds until the appliance automatically jumps back to coffee mode. If "OK" is not pressed, the appliance 3 automatically returns to the coffee mode after about 120 seconds without 0 saving the entries. [. . . ] 0 Warm up the brewing unit with the rinsing programme before making coffee (see , , Rinsing" page 122). The coffee does not have enough crema · The coffee is too coarsely ground. Attention: The brewing unit can only be taken out when the appliance is switched off using the On/Off button at the front of the appliance. If you try to take out the brewing unit whilst the coffee machine is switched on, this could be seriously damaged. [. . . ]