User manual AEG-ELECTROLUX ERD18000W8

[. . . ] During transportation and installation of the appliance, be certain that none of the components of the refrigerant circuit become damaged. ­ avoid open flames and sources of ignition ­ thoroughly ventilate the room in which the appliance is situated · It is dangerous to alter the specifications or modify this product in any way. Any damage to the cord may cause a shortcircuit, fire and/or electric shock. Any electrical component (power cord, plug, compressor) must be replaced by a certified service agent or qualified service personnel to avoid hazard. [. . . ] The insulation foam contains flammable gases: the appliance shall be disposed according to the applicable regulations to obtain from your local authorities. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. Switching off To turn off the appliance, turn the Temperature regulator to the "O" position. Turn the Temperature regulator toward lower settings to obtain the minimum coldness. ⷠTurn the Temperature regulator toward higher settings to obtain the maximum coldness. However, the exact setting should be chosen keeping in mind that the temperature inside the appliance depends on: · room temperature · How often the door is opened · In this case the dial must be set to a higher temperature to allow automatic defrosting and therefore reduced energy consumption. Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. Freezing fresh food The freezer compartment is suitable for freezing fresh food and storing frozen and deep-frozen food for a long time. To freeze fresh foods it is not necessary to change the medium setting. However, for a faster freezing operation, turn the temperature regulator toward higher settings to obtain the maximum coldness. This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore only be carried out by authorized technicians. periodic cleaning The equipment has to be cleaned regularly: · Clean the inside and accessories with lukewarm water and some neutral soap. ⷠRegularly check the door seals and wipe clean to ensure they are clean and free from debris. Do not pull, move or damage any pipes and/or cables inside the cabinet. Never use detergents, abrasive powders, highly perfumed cleaning products or wax polishes to clean the interior as this will damage the surface and leave a strong odour. Clean the condenser (black grill) and the compressor at the back of the appliance with a brush. This operation will improve the performance of the appliance and save electricity consumption. Many proprietary kitchen surface cleaners contain chemicals that can attack/damage the plastics used in this appliance. For this reason it is recommended that the outer casing of this appliance is only cleaned with warm water with a little washing-up liquid added. Defrosting of the refrigerator Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal use. The defrost water drains out through a trough into a special container at the back of the appliance, over the motor compressor, where it evaporates. [. . . ] It must be possible to disconnect the appliance from the mains power supply; the plug must therefore be easily accessible after installation. To carry out the following operations, we suggest that this be made with another person that will keep a firm hold on the doors of the appliance during the operations. Reposition, level the appliance, wait for at least four hours and then connect it to the power socket. In case you do not want to carry out the above mentioned operations, contact the nearest After Sales Service Force. [. . . ]