User manual AEG-ELECTROLUX ERE3500X

[. . . ] If the refrigerating system is access to the operating controls or the inside of punctured, the cabinet will be damaged and the cabinet. foodstuff inside may spoil. Scrapping old cabinets The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negativ consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. [. . . ] To loosen the holder from the shelf, bend the hooks/brackets that surround the backside of the shelf. Hints and Tips Saving energy · Pay careful attention to where the cabinet is placed. Try to avoid keeping the door open for long periods, or opening the door too frequently as warm air will enter the cabinet, and cause the compressor to switch on unnecessarily often. Ensure there are no obstructions preventing the door from closing properly. This will ensure safer defrosting of foods and reduce the work of the refrigeration unit It is advisable to periodically clean the refrigeration system at the back of the appliance with a duster or vacuum cleaner. Always leave warm food to cool down to room temperature before placing in the fridge. compartment. GB · Avoid buying frozen food if you can not store it straight away. When you arrive home place the frozen food in the freezer immediately. Ensure that food placed in the freezer is dated and labelled and used in date order to ensure that food is consumed at its best. Remove suspect food from you refrigerator and clean, refer to cleaning and maintenance. · · · · · · · Protect the environment · Hand over the cabinet packaging and discarded fridges and freezers to a recycling station. Contact your local council or Environmental Health office for more information. · avoiding frequently opening the door or keeping it open too long. When moving the cabinet, lift it by the front edge to avoid scratching the floor. To change the light bulb The light is switched on automatically when the door is opened. Before replacing the light bulb, disconnect the power plug from the outlet. Keep the packaging on to hold the bulb when setting it into the socket. Use a clear halogen light bulb. 41 G4 UV-blocked 20W/12V Low pressure Electrolux 818 38 38-00/5 Change of carbon filter To maintain the best performance the carbon filter should be changed once a year with normal usage. The filter is placed behind the grill and can be reached by opening the cover. The cover can be opened by simultaneously pressing the lever on the right of grill (1) and turning the cover outward (2). The new carbon filter is placed in the existing slot The filter should be handled carefully so fragments don't loosen from the surface. 1 2 3 When the appliance is not in use Disconnect the appliance from electricity supply. Empty all foods and clean the appliance, leaving the doors ajar to prevent unpleasant smells. If the cabinet will be kept on, ask somebody to check it once in a while to prevent the food inside from spoiling in case of a power failure. Something Not Working Before contacting your local Service Force Centre check the following point: GB Problem " " is displayed in the temperature display. Possible cause / Remedy An error has occurred in measuring the temperature. (The cooling system will continue to keep food products cold, but temperature adjustment will not be possible. ) Set a lower temperature. Distribute the food products to allow cold air to circulate around them. Make sure that the door is completely closed and that the insulating strip is complete and clean. [. . . ] Check that the drain hose at the rear of the cabinet discharges into the drip tray. The power plug must be accessible after installation of the cabinet. Electrolux 818 38 38-00/5 45 Door Reversal 1. Later, when raising the cabinet, it will be easier to grip under the cabinet thanks to the board. Remove the door-closing fittings from the hinge and put the hinge pin on the other side. [. . . ]