User manual AEG-ELECTROLUX ESF 2435

[. . . ] Contents For the user Safety information Description of the appliance - Spray arm - Coarse strainer/microfilter - Fine filter - Detergent dispenser - Rinse aid dispenser - Water softener - Cleaning the dishwasher For the installer 3 4-5 Technical specifications Unpacking - Damages - Use - Positioning - Protecting the dishwasher against freezing 13 14 Installation 6 7 8 9 - Water inlet - Water drainage - Electrical connection 15 The control panel - How to set the delayed start Gebrauchsanweisung 16 Adjusting the water softener Programme chart Using the appliance - Starting the programme - Stopping the programme temporarily - Cancelling the programme - Pause function - Cancelling the drying phase - Switching the dishwasher off Loading and unloading In the event of a fault Service - Service and spare parts 10 11 12 12 Information for test centres Guide to use the instruction book The following symbols will be found in the text to guide you throughout the instructions: Safety information Step by step instructions Hints and tips Environmental information -2- Safety information Before installing and first using the dishwasher, read this instruction booklet carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the dishwasher are thoroughly familiar with its operation and safety features. Save these instructions and make sure they remain with the dishwasher if it is moved or sold, so that everyone using it through its life can be properly informed on appliance use and safety. Installation and servicing q q Do not place sharp knives with their points upwards. Ensure that the door of the dishwasher is always closed when it is not being loaded or unloaded. [. . . ] Adjust the water softener according to the table below for the water hardness level for your area. Contact your local Water Authority to find the exact water hardness level for your area. The water softener has 5 settings: Water hardness level °d 1) > 24 18 - 24 12 - 18 4 - 12 below 4 mmol/l 2) > 4, 2 3, 2 - 4, 2 2, 1 - 3, 2 0, 7 - 2, 1 below 0, 7 Setting on the water softener 5 4 3* 2 1 no salt is needed Number of light flashes 5 4 3 2 1 In the following settings the dishwasher must be switched off and all programmes completed. See chapter "Using the appliance" for information on how to complete the programme. Press the combination buttons simultaneously and hold them pressed in. When the first three programme indicator lamps starts to flash, you can let go of the buttons. The lamps for the water softener and for the ended programme cycle starts to flash. - The number of flashes for the ended programme cycle are equivalent with the set water hardness level. - This sequence of flashes is repeated several times after a few seconds pause. Put the correct amount of detergent into the detergent dispenser and close the dispenser lid. During the three seconds the two top indicator lamps are flashing, you can select another programme cycle. The lamp allways indicates which part of the selected cycle the dishwasher is in. Check the strainers/filters to see if they need to be cleaned when the dishwasher has finished the programme. If both the top and middle indicator lights are flashing, first check that the door is properly closed, otherwise read the section "In the event of a fault". Pause function With the paus function the programme can be temporarily disrupted for a short period of time. When you want the programme to continue again, you press the On/Off button. The programme should not be paused for any longer than necessary, because the water inside the dishwasher has cooled down and must be heated again which increases the power consumption. Cancelling the drying phase In case you do not want to wait until the drying phase is completed, you can cancel it. The drying phase is cancelled. Switching the dishwasher off Switch the dishwasher off, when the indicator lamp for the programme cycle end is lit. Be careful if you open the door immediately after the programme is finished, since hot steam may escape. This washing system varies both the revolutions of the pump and the water pressure for more intensive cleaning of the dishes during a programme. That is why different sections of the programme cycle do not sounds the same. Stopping the programme temporarily 1. Open the door carefully when the dishwasher is running, since hot steam may escape. Cancelling the programme 1. Press and hold in the combination buttons until the indicator light for the programme goes out. [. . . ] If you discover any damage, faults or that anything is missing, you should notify the dealer immediately. Never leave packaging material in a place where children may play with it. Check that the following accessories are supplied with the dishwasher when you unpack it: ­ A funnel for filling salt (1) ­ Elbow for discharge hose (2) 1 2 Use This dishwasher is designed solely for washing household utensils suitable for washing in a dishwasher. Using it for other purposes may damage it and invalidate the guarantee. Positioning The dishwasher is intended to be installed on a kitchen sink, worktop or built-in. [. . . ]